Electronics Forum | Wed May 08 11:07:54 EDT 2002 | Carol Stirling
We have a concern with moisture absorbtion/humidity effects on PWBs specifically used for automated SMT (including BGA). I'm sure there is a IPC spec on this and would appreciate the number - I've searched the IPC web-site -no results. Could you t
Electronics Forum | Tue May 21 17:25:28 EDT 2002 | Carol Stirling
Hi Dave F, Thanks for the reply, the question was Customer driven. Could you clarify your recommendations for heat sealed moisture barrier bags please - does this include Nitrogen vac pack? Our production runs are small, so there is an investigat
Electronics Forum | Tue May 28 22:06:09 EDT 2002 | arcandspark
Two hours at 125 C will do nothing. IPC's new spec is 48 hours at 125C, the old spec I use to use for years was 24 hours at 125C. I do not have all the spec in front of me but if you reduce the temp to around 60C it can take up to 48 days. We use to
Electronics Forum | Tue May 28 22:06:18 EDT 2002 | arcandspark
Two hours at 125 C will do nothing. IPC's new spec is 48 hours at 125C, the old spec I use to use for years was 24 hours at 125C. I do not have all the spec in front of me but if you reduce the temp to around 60C it can take up to 48 days. We use to
Electronics Forum | Fri Sep 13 13:43:48 EDT 2002 | barryg
You right Simon, this forum is not for that type of question, but since you have been polite and desperate, i'll shoot some help. Your right, sounds like it is the unit, there is probably a component failed that is shutting down the unit when it gets
Electronics Forum | Tue Dec 07 13:40:25 EST 1999 | Tim
The company I represent provides electronic manufacturing services. Some of my customers ask that we ship their boards "un-tested". By un-tested I mean we build them, visually inspect them and out they go. I find that on un-tested boards, it's not
Electronics Forum | Thu Mar 05 16:25:27 EST 1998 | Brian Stumm @ ETS
| I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. | Is it possible to reflow without damaging the tape. Any suggestions? Do you have a profiler for your reflow oven?
Electronics Forum | Mon May 27 12:24:21 EDT 2002 | arcandspark
Carol, I beleive there is an IPC spec for Moisture control. We see all kinds of problems with boards coming from the vendors. We use to bake all bare fabs upon recieving them. This helped alot but waste time. We now rely on the board vendors to bake
Electronics Forum | Fri May 31 10:35:46 EDT 2002 | dason_c
I think that the IPC spec only apply to the MSD. I had a paper from Lucent and forwarded by Francois Monette, please aware that the first 2 hours, the moisture doesn't bake out from the assembly/component and result show that it is increase the weigh
Electronics Forum | Fri Sep 13 11:50:03 EDT 2002 | dougt
What is happening is your bench supply is unable to supply enough current so the voltage drops. When you turn up the volume knob your asking for more current and the voltage drops more (the led's in the faceplate dim). It also sounds like when you
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
