Electronics Forum | Sun Aug 24 23:19:34 EDT 2014 | darby
I have 2 x CP45FV, 2 X CP45-Neo FV and 2 X Tenryu FV7100V (forerunner of M2. Personally, I think the machines are about equal although CP-45 are probably easier to operate and program. The i-Pulse are a bit more eccentric and programming and operatio
Electronics Forum | Tue Oct 05 02:24:58 EDT 2004 | darby
What config are you replacing? ie 1 machine, 2 x 3machine lines, 1 x 2 machine line etc. What do you want to place with it? I can't comment on the Contact machines having never used one. On Samsungs I will say this. For your own benefit consider the
Electronics Forum | Tue Sep 23 07:44:24 EDT 2003 | Peter VanHeusden
Shortlisted a Samsung machine CP45FV for purchase > for a medium speed application. Any feedback on > your impressions of Samsung machines in general > and also in terms of company, service, support, > software etc. that you would like to share w
Electronics Forum | Fri May 21 17:41:01 EDT 2021 | jamesatqkits
Hello, This is my first time posting to this forum, or forums in general, so go easy on me. I have just acquired a CP45FV NEO, "My other car is a CP45FV NEO" anyways, when I try to put the machine into ready mode I get the error, [0006] I/O power
Electronics Forum | Wed Aug 03 10:09:27 EDT 2011 | geb
Our Samsung CP45FV Neo is out of warranty, but due for its annual calibration/ service, however we are wondering whether it is really needed. The line only runs for 8 hours a day 5 days per week (including setup), so not heavy usage. The manual does
Electronics Forum | Mon Dec 02 10:33:46 EST 2013 | sarivong0914
Hello all, We have a Samsung CP45FV Neo, and I'm having problems with the operating software. I have a PCB with 2 different rev's. Rev. A boards was programmed to run Vertical. Then Rev.B boards are horizontal but was programmed to run vertical.
Electronics Forum | Fri May 29 06:07:47 EDT 2015 | buckcho
Hello, it is important to decide to work either with pcb or with opt files (we use only pcb), I dont recommend mixing them. When you open the pcb file, make changes, optimize it to opt file, then make save as.... and here is the trick I know - save t
Electronics Forum | Mon May 16 00:33:18 EDT 2016 | wesleyintelli
Our CP45 swing mirror motor (Panasonic AC Servo Motor: MSMA012A3A) recently jammed and required replacement. I replaced the motor with a new one however it won't home. A link to a video of the motor attempting to home can be seen below. I am wonderin
Electronics Forum | Fri Aug 26 19:59:02 EDT 2016 | mhanrahan
We've just purchased a CP45FV Neo to replace an ancient Panasonic line. First non-Panasonic placement equipment I've worked on, so learning as I go here. So far it's been pretty straightforward. However, we use some parts that come in QFN or LCC p
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
