Electronics Forum | Mon Nov 22 11:36:32 EST 2010 | mmjm_1099
I just has this issue and replaced the MIU card. I ordered it from IBE SMT. Make sure to troubleshoot before purchasing anything of course.
Electronics Forum | Wed Sep 26 00:24:14 EDT 2012 | elefu
The bulb is bright but nothing shows on the screen. It will not see anything above it. If I put an LED by it the light shows on the monitor. Any ideas?
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Thu May 20 11:04:31 EDT 2004 | SWagner
I do not think it's your power supply, its probably the monitor, I spent two days nearly four years ago on this problem, the 265's power supply can be dropped out by a problem with any of the voltages, they are not isolated. Try using a known good c
Electronics Forum | Sat Sep 22 20:20:13 EDT 2012 | dekhead
You don't say which 265; presumbly since you say "bulb" it is either MK1 or GS with shuttered camera. Both those machines have potentiometers to control light levels. MK1 is on machine frame inside drop down (stencil load) door, near serial tag. GS
Electronics Forum | Mon Feb 02 12:26:24 EST 2004 | kauer
cd{space}mint. At the mint directory type C:>MINT/load. Re-start using ctrl+alt+del when mint is finished loading, it will sayC:MINT/. Note: If your Machine comes back to life, Do Not turn off main power until You can replace those batteries, with t
Electronics Forum | Mon Feb 02 12:46:36 EST 2004 | kauer
Just a hunch, pull out and re-seat the cards. also check power supply voltage. We bought 2 used machines and one of them would not boot up, the software would just go in a loop. Turns out the 5 volt power supply was low, 4.85v. just low enough to cre
Electronics Forum | Mon Feb 02 14:06:27 EST 2004 | jsk
I did reload mint. When i do this the machine runs fine for about 15 minutes, but i have to continue loading boards. If I let the machine idle for 3-5 minutes, i get the error. We are a low volume manufacturing company, so on a 20 piece run i will re
Electronics Forum | Thu May 20 09:20:08 EDT 2004 | jsk
Voltage checks out ok after i unplug the monitor and unplug the dc voltage suppy to the y1 enclosure. I lose the 24v and 5v line completely when i plug these in and voltage drops on the +12v and -12v, which leads me to believe a bad power suppy. What
Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
