Electronics Forum | Wed Jul 28 07:59:50 EDT 2004 | cyber_wolf
Ken, With all due respect: Surface mount is surface mount. Whether you are placing 0201's, or PLCC84's the basic concept is the same. So I would surely hope that for the most part my process is transferable. I guess I was too broad when I said "we n
Electronics Forum | Wed Jul 28 20:56:58 EDT 1999 | Dave F
| Currently, we are baking any PCB before process on SMT, the 'reason' is to dry any possible humidity that could be inner the PCB, it does not matter if the PCB is multilayer or not. We bake PCB's at 107C for 4 hrs and the board must be process into
Electronics Forum | Tue Jul 03 08:14:49 EDT 2001 | Stefan Witte
If you hold your board sideways in a 90 degree angle you apply a force of 1 g to your components. 1 g translates into 32 ft / sec. square. This is not too much acceleration for fearless roller coaster drivers but Melf�s and Tantalums can fall off at
Electronics Forum | Thu Jul 29 00:23:45 EDT 1999 | ScottM
| Currently, we are baking any PCB before process on SMT, the 'reason' is to dry any possible humidity that could be inner the PCB, it does not matter if the PCB is multilayer or not. We bake PCB's at 107C for 4 hrs and the board must be process into
Electronics Forum | Thu Jul 29 12:33:38 EDT 1999 | Wolfgang Busko
| Currently, we are baking any PCB before process on SMT, the 'reason' is to dry any possible humidity that could be inner the PCB, it does not matter if the PCB is multilayer or not. We bake PCB's at 107C for 4 hrs and the board must be process into
Electronics Forum | Tue Jul 27 06:04:16 EDT 2004 | cyber_wolf
Grant, I know of a couple places that throw their paste out at the end of the day. I have worked in SMT for over 15 years and we have never thrown paste out unless it was contaminated, or dried out. We have never had a problem. If you ask me, I would
Electronics Forum | Fri Nov 07 12:48:31 EST 2003 | rholland
I have seen in the last couple of months more boards with a white hazing under the solder mask. I ran a few tests on a board to determine the cause of the white hazing underneath the solder mask. First I confirmed, or at least I think I confirmed, t
Electronics Forum | Wed Feb 14 16:58:12 EST 2018 | cbart
you would be best to get this from your paste/solder manufacture. but here are some rules of thumb: -Solder paste out of fridge before use - get out the night before needed.. don't let your op's warm on the oven!! you will regret that! if not over ni
Electronics Forum | Wed Jun 22 01:57:28 EDT 2016 | sachinverma
we face the problem to last month dry solder issue.when we found PCB is dry. (PTH not fill not properly)then we change the parameter like flux Tank pressure increase 130 to 250. after these activity PCB is ok no dry solder found......but problem is o
Electronics Forum | Fri Jul 01 07:19:12 EDT 2016 | sachinverma
Dear sir, how check the pressure sensor its software baseed.
