Electronics Forum | Thu Dec 09 04:32:56 EST 2004 | chad
I'm currently using Electrovert Vectra's right now. They do really well. I was actually in New Hampshire last month looking at Vitronics Soltec's newest wave soldering machine too. I think they would be worth a look as well. Good Luck!
Electronics Forum | Mon May 14 13:56:54 EDT 2007 | jdumont
Agreed, I just bought a Electrovert Vectra Elite and have been very pleased with it thus far. I got the dual pot option for lead free changeovers and that has worked great. I can change pots in under 5 minutes, not counting the time to warm up.
Electronics Forum | Wed Jul 25 10:27:51 EDT 2018 | mefloump
We have an Ersa Powerflow N2. It's a very well built machine with excellent support. We run it (2) 10 hr shifts per day, 4 days a week. Having the full nitrogen tunnel has greatly reduced dross and improved hole fill. This replaced an Electrovert Vec
Electronics Forum | Tue Jan 17 17:28:47 EST 2006 | mrduckmann2000
Adlsmt, We had an issue where an Engineer setuo his own passwords on our machine, he was then laided off and nobody knew the passwords. Electrovert gave us the following passwords to try: Electrovert Wave Solder Logon Id Supervisor Password Pass
Electronics Forum | Mon Jun 27 15:02:55 EDT 2005 | cmiller
Thanks for the reply. I had the instructions out of the manual but after re-programming we had all kinds of wierd stuff going on. After re-setting the PC several times it worked fine. Can I get a copy of the instructions you have? It would be appreci
Electronics Forum | Fri Jun 24 13:56:05 EDT 2005 | John S
This is a little late, so I hope you've been in contact with E-vert. We've experienced the same thing on our two vectra's. It normally happens right after a bad electrical storm. The shared drive will have to be reprogrammed. E-vert can fax you a
Electronics Forum | Tue Aug 24 05:02:55 EDT 2004 | dj_jago
Hiram, We have just had the same decision to make! I was at Vitronics Soltec, Holland about 4 weeks ago doing trials for Lead Free. The Soltec Delta machine was ultimatly chosen over price verses performance. Both machines are very capable but
Electronics Forum | Fri May 11 09:17:12 EDT 2018 | charliedci
I have used a 2006 Electrovert Vectra ES (63/37) for last 3 years, we acquired it used. It had little or no maintenance before we got it, now after replacing a solder pump motor, preheater fans and thermocouples it is pretty reliable. The spray fluxe
Electronics Forum | Thu May 24 22:10:38 EDT 2007 | john3140
Selective!If you are considering a Selective machine you must not be worried about thru put. If you want to keep the same thru put as what you were getting out of the Soltec Wave but want better software....you should give a Vectra ES a try. Its manu
Electronics Forum | Mon Mar 07 22:23:40 EST 2005 | mrduckmann2000
Ken, You nailed it! We have a Electrovert Vectra wave solder machine that will erupt solder all over the place while heating up, we had to disable the timer because of all the solder splatering. Electrovert told us that our machine had a small des