Electronics Forum | Mon Jun 26 17:49:07 EDT 2006 | flipit
Mark, You should check the way the paper is installed. I found that the Dek265LT documentation said to install the roll one way. The rolls we were buying from JNJ Industries stated to install the paper another way. I then found that one operator
Electronics Forum | Tue Jan 30 10:43:18 EST 2007 | darburch
Before you do anything to the windmills check the heights in your PD's and if you are using board supports be certain that they are set correctly. The CP 65 has approx 1.8mm of travel before the pin will get stuck, as the nozzle should only deflect .
Electronics Forum | Tue Jan 30 12:21:49 EST 2007 | cyber_wolf
Rob, I have talked about this on the forums before. I have since then gained much more experience on this issue. Some things to look at : 1. The X/Y/Z table must be indicated flat. (See the Fuji manual for specs.) 2. Your Z-origin must be correct.
Electronics Forum | Fri Feb 29 08:27:34 EST 2008 | tbkonrad
This morning I turned on our Qsv-1 and ai resiveved the following error. "Clamp did not open: House Air pressure may be lower then 70 psi" after checking the Air Pressure it reads at 80 psi on the Main air pressure gauge as well as the 80 psi on the
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Thu Oct 20 19:23:18 EDT 2011 | eadthem
As far as the buttons go, White = pause for inspection when depressed, lit when active Green = pass after inspection when lit you need to press the button, when flashing its waiting for the upline machine, Yellow/orange = when flashing indicates
Electronics Forum | Wed May 02 09:25:09 EDT 2012 | tbouslog
Our company has recently changed the way our cage gives our SMT Department their parts to try to better control inventory. SMT now instead of recieving reels recieves strips with only 2-20 extra parts depending and the size/cost of the part. Does any
Electronics Forum | Thu Aug 07 15:27:57 EDT 2014 | tombstonesmt
We splice all day. We use sierra splice tool and their yellow splice. Technique that I found works very well is to peel back the cover tape of new reel over two empty slots (our machine detects when splice occurs and allows two empty slots without re
Electronics Forum | Tue Feb 16 15:42:21 EST 2016 | sarason
When faced with a problem like this I sometimes look at competitive products and see what they have done. You may be able to get away with 4 layers if you have the space, however if it is jammed up that will not be an option. I presume that the total
Electronics Forum | Mon May 16 00:33:18 EDT 2016 | wesleyintelli
Our CP45 swing mirror motor (Panasonic AC Servo Motor: MSMA012A3A) recently jammed and required replacement. I replaced the motor with a new one however it won't home. A link to a video of the motor attempting to home can be seen below. I am wonderin