Electronics Forum | Mon May 02 10:36:22 EDT 2016 | ilavu
Where are you located? I have calibration kit and some programming experience too.
Electronics Forum | Wed Apr 26 01:59:01 EDT 2023 | ttheis
Thanks, what about the camera calibration? Does it use the same kit as the GSM machines?
Electronics Forum | Mon Nov 13 13:16:12 EST 2000 | Sal
Guys Has anyone had good or bad experiences with the ECD Oven/Wave rider piece of kit ? Before I ask my manager to break the bank to pay for this kit what I would like to know is what will it do for me ? but more importantly will it give the custome
Electronics Forum | Thu Oct 05 16:48:41 EDT 2000 | LarryK
Has anyone ever used the circuit repair kits? The type where you can replace a PTH or SMT pad that has been lifted or damaged? It appears that you just select a pad, trace or whatever needs replacing from a panel and heat or glue it onto the board.
Electronics Forum | Thu Oct 05 17:05:36 EDT 2000 | JAX
These types of foil kits work just fine as long as they are used before expiration. Scraping off the epoxy coat gets a little tough on fine pitch pads and etches. I have always like to use a solder sample board to retrieve my bits & pieces from whene
Electronics Forum | Thu Mar 23 22:20:51 EST 2000 | Dave F
Chris: I'm unsure about the kits you seek. Solderability of: * Components: J-STD-002, Dip And Look Method. Malcom Instruments makes a very nice tester. * Boards: IPC TM-650 2.4.12A Solderability, Edge Dip Method Good luck Dave F
Electronics Forum | Fri May 04 08:23:17 EDT 2001 | Dave Brady
No titration is needed for a fluxer that has a closed flux flow system such as a Opti fluxer. The flux is fed from a pressurized vessel directly to the applicator with no evaporation or change in the flux composition. I hope this helps. If you need
Electronics Forum | Wed Feb 09 13:25:08 EST 2005 | jdumont
Good day all, I am wondering if there is a company out there that sells kits that contain a board, components and the stencil? When we get our new reflow and wave machines in I will need numerous boards to run and evaluate until I can get the process
Electronics Forum | Wed Jan 25 13:38:58 EST 2006 | mrduckmann2000
I have used Winslow preforms several times.....sometimes with great results and others with not so good. It just depends on the BGA. I have a custom ASIC that will not re-ball, Winslow has even had trouble re-balling them. I would suggest using an
Electronics Forum | Wed Jan 25 17:12:41 EST 2006 | adrian_nishimoto
Billy, I think the most versatile kit out there is the RB-2000 system from Mini Micro Stencil. We have not run into a part yet that we could not reball, even ones with a raised encapsulated center. They even make custom screens that match the compo