Electronics Forum | Wed Aug 19 03:24:49 EDT 2015 | pcbman
I ordered few times of prototyping gold plating > pcb from China. How to i differentiate they are > ENIG or Flash gold? Hi,Friend , this is very easy to distinguish the ENIG and gold plating pcb, you can stratch the solder mask off and see the co
Electronics Forum | Fri Nov 12 17:58:18 EST 1999 | Jason Nipper
I have been actively experimenting with Selective WS pallets fabricated from Delmat. I need feedback from users on life expectancy, demesion constraints relative to warpage or degradation, and any useful info on ways to maximize life and prevention
Electronics Forum | Wed Apr 21 13:21:33 EDT 1999 | Scotty
Does anyone have any experience with soldering 50mil pitch BGA's that have a via in the pad, the size is .012 The via will be masked off on the bottom side of the board. Need to know what precautions or problems if any I might encounter. The process
Electronics Forum | Fri Apr 02 01:05:34 EST 2004 | Grant Petty
Hi, Thanks for the info. How clean can wave soldering get? We are looking at a carrier that masks off most of the board when we run it through the wave, so hopefully this works. Regards, Grant Blackmagic Design
Electronics Forum | Wed Sep 23 21:40:29 EDT 2009 | davef
We apply temporary solder mask off line, using a programmable dispense head. Works fine. Purchasing a placement machine with a dispense head usually only works-out well for the sales-type. Not in every case, but usually.
Electronics Forum | Wed Mar 24 00:03:20 EDT 2010 | boardhouse
Hi Itzik, it looks like you receive a board from your manufacture that they did solder mask rework on. it looks like they stripped tried to strip the mask off the board. Was this the only board that was like this or did the whole order look like th
Electronics Forum | Thu Jun 01 10:48:21 EDT 2000 | Jeremy
I am having a problem with the green solder mask flaking off exposing bare copper. The mask was defective from the board manufacturer. My problem is the boards are already assembled and we are just finding the problem. Is there a standard that cover
Electronics Forum | Mon Dec 28 15:43:22 EST 1998 | Mark D.
We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I realize th
Electronics Forum | Mon Dec 28 19:28:57 EST 1998 | Chad Haima
| We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I realize
Electronics Forum | Thu Nov 03 10:49:11 EST 2005 | russ
This is what I would propose, Place and reflow the board without the BGA with your lead process, remove the solder from the BGA pads if you cannot mask off the apertures in your stencil. Then place the BGA and reflow to SAC requirements with a rewo
winsouce.jpg)