Electronics Forum | Thu Oct 11 06:09:50 EDT 2018 | mk15
hello, Does anyone know about the error F-MOT-MOVE X/245 Motor drive inhibited. The machine hardware initiation ready and approximately an hour later, you will see an error. Thanks
Electronics Forum | Thu Oct 18 16:09:34 EDT 2018 | emeto
Interesting. What changes in 1 hour? Is there any connection between the error and feeder/magazine change, load reload? Is there any other factor observed in the hour of work that is abnormal?
Electronics Forum | Fri Oct 19 08:35:52 EDT 2018 | stephendo
IIRC There is a friction test? If I remember correctly, what is the result?
Electronics Forum | Tue Oct 23 11:19:46 EDT 2018 | tech1
This wound up being a power supply cutting out after a period of operation.
Electronics Forum | Thu Oct 25 01:13:55 EDT 2018 | mk15
thank you for your advice, the problem was in the elmo source 350V, there was a problem of dropping voltage when the engine accelerated.
Electronics Forum | Fri Jun 03 14:21:48 EDT 2011 | rgduval
I haven't seen that particular fail....but... What was the failure with the M controller? Might try moving your MOT cards around, to see if the failure follows one particular card. If so, you'll know you need a new MOT card. That might satisfy th
Electronics Forum | Fri Jun 03 15:19:19 EDT 2011 | jeremymc
After reseating the M controller boards I was able to get further than I had previously, no save status error, and was given an error about the voltage being wrong. During my last run my company had an electrician in to rewire somethings and put a
Electronics Forum | Mon Jul 16 10:45:47 EDT 2012 | cyber_wolf
The trandsducer on the motor.
Electronics Forum | Tue Dec 18 21:47:14 EST 2012 | jaimebc
So just to update and close this thread, it was the ZFIB board ( the one mounted on top of the theta motor) that was causing the theta motor to error out) Problem fixed. $ 30 dls or so from MYDATA. Hope this helps some one down the road.
Electronics Forum | Thu Nov 15 23:45:53 EST 2012 | jaimebc
robgd3, The Z motor can be purchased separately, however, the theta motor can't. You need to buy the whole midas head. I didn't get as far as dissembling the theta motor casing to get to the theta motor. That was my worse case scenario. We ran thou