Electronics Forum | Thu Jul 19 17:10:43 EDT 2007 | jamyboy
You might want to check the Xwagon bearings. We had the same issue with the TP9-UFP we ordered all the possible parts Xmotors small large, encoder, transducer, couplings etc. over 10K worth of parts. The only thing we didnt order was the actual x-wag
Electronics Forum | Wed Jun 27 12:51:53 EDT 2012 | cyber_wolf
You can leave the booster in the original position and mount two small fans directly underneanth it blowing upward. By leaving it in the original upright position you get quite a bit of air velocity in the small space between the booster and the mach
Electronics Forum | Fri Jul 20 05:09:42 EDT 2007 | allgood
Yes that sounds worth a look - thanks. I am also wondering if there is a thermal issue - we had 27 degrees in here yesterday and I remember the Mydata guy telling me to put a desk fan onto the card frame in the summer. I did this last year - when I
Electronics Forum | Wed Jun 27 03:43:24 EDT 2012 | allgood
Very interesting - esp that you have removed the temperature variable by being airconditioned. We defeinitely do not get strikes at 74 but do at 80 - but also we dont start the machine when its 80, that is the afternoon tempertaure on a rare hot day
Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Tue Jul 17 11:15:05 EDT 2007 | allgood
We keep seeing a problem with the plastic tool tip on an A12 tool being sliced off. I think it is hitting the edge of the tape separator clip assembly - I determined this by coating the tip in paint and then finding where the tip had struck the meta
Electronics Forum | Wed Jul 18 03:55:39 EDT 2007 | allgood
Thank you for the reply - and yes its a TP9-UFP! Problem doesnt happen all the time and may not happen for extended periods on the job where we see it most - this particular job uses all feeder slots so the head is whizzing back and forth quite a l
Electronics Forum | Wed Jun 20 12:16:59 EDT 2012 | allgood
Hi John Yes I am still having the same problems years later! It keeps Fred in work supplying me with replacement tips too! Mydata came up with a supposed fix to alter a parameter called prepick which puts a pause in I think allowing the head to st
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Thu Jul 19 04:23:38 EDT 2007 | chrispy1963
You dont mention if it is ONLY occuring with the A12 or is it other tools as well? Only spring tools or Stiff ones? Regardless of that, the small X Wagon motor is controlled by the track ball and the bigger X Axis motor is controlled by the joystic
