Electronics Forum | Mon Apr 16 20:04:24 EDT 2012 | hegemon
6 or 7 replies and 3 *flamer* ratings already? And here I thought this was good info above...
Electronics Forum | Wed Jun 26 04:00:30 EDT 2019 | SMTA-David
Thanks, I'll take a look. Something else I found was the Z height for the module was set to 1.7mm but I am picking up the part on the PCB surface which is only 1.0mm from PCB being loaded, therefore the part must have been let got 0.7mm above PCB an
Electronics Forum | Fri Aug 20 12:06:53 EDT 2004 | danhui888
Pls contact ECD for built in monitoring system or KIC 24/7. This products will monitor your oven performance and profile round the clock without stopping. If your profile is out of the spec, the software will gives you an alarm and the machine will s
Electronics Forum | Fri Aug 20 12:06:55 EDT 2004 | danhui888
Pls contact ECD for built in monitoring system or KIC 24/7. This products will monitor your oven performance and profile round the clock without stopping. If your profile is out of the spec, the software will gives you an alarm and the machine will s
Electronics Forum | Mon Feb 12 13:58:10 EST 2007 | campos
Tks for the answers,, My concern is about the intermetalic layer,,I run SMQ230 LEAD FREE paste.. its liquidous at 217C..the oven have 7 zone, but I run in 5 zones also with a more agressive profile (due to the line rate)..I would like to know if runn
Electronics Forum | Wed Oct 10 07:01:05 EDT 2007 | jdumont
I agree, I have been doing this for years also. Never found anything that the oven wasn't already telling me. I will however be investing in the KIC 24/7 constant monitoring device soon. Price isn't too bad for what you get. Customers like to get a w
Electronics Forum | Wed Jan 04 10:34:04 EST 2006 | DannyJ
I don't believe you are missing anything, Amol. Mainly, you just need to make sure that your oven handles the higher temperatures needed for reflow. Also, there has been a lot of discussion on how many zones are needed to properly reflow lead-free
Electronics Forum | Thu Apr 15 11:53:37 EDT 2004 | Claude_Couture
Hi everyone, Our QC manager is bugging me about calibrating the TC readings on our reflow ovens. I keep telling him that doing a regular reflow profiling with a mole is sufficient to see if the oven temperature are normal. The manuals state that TC c
Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie
We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro
Electronics Forum | Wed Sep 12 11:01:49 EDT 2007 | leemeyer
We have an Omni 7. We were having problems where blowers wouldn't start. Turned out to be the start capacitors and not the blowers. I replaced all of the caps and haven't had any issues since.
