Electronics Forum | Tue Mar 09 14:22:09 EST 2004 | billschreiber
There is an article on our web site by Richard Clouthier, �SMT Stencil Cleaning: A Decision That Could Impact Production.� He talks about how high pressure sprays can damage the delicate land mass areas between fine-pitch apertures. High pressure ai
Electronics Forum | Fri Jun 11 17:23:12 EDT 2004 | steve
Sorry for coming in so late on this discussion. For what it is worth. The dross reclamation equipment that I have looked into cost's alot of money. Thus you better do the math on the average amount of dross produced versus the cost of the equipment t
Electronics Forum | Wed May 07 18:23:52 EDT 2008 | adamcrum
The reason my company was fined, was because they faile to file a one page document stating that they disposed of more than 100lbs of leaded solder in a year. The fine was not for creating toxic waste, as we diposed of the solder PROPERLY in accorda
Electronics Forum | Tue Dec 11 10:56:24 EST 2012 | rway
Juggalo, Your boss obviously hasn't thought about the implications of taking a complacent attitude toward safety can cost. He is liable if someone gets hurt working in his plant who isn't wearing the proper safety equipment or none at all. It does
Electronics Forum | Thu May 18 21:46:21 EDT 2000 | Dave F
Scott: First, it's neat that you do cartridge monitoring on you staff. We do that once a year. We (and I assume others) are responding to OSHA requirements: Lead CFR 1910.1025 permissible exposure limits for lead, provisions for medical examinati
Electronics Forum | Mon Jun 07 10:57:31 EDT 1999 | Dave F
| | | | Where I can find some informations about repairing of SMT boards? | | | | | | | | Thanks | | | | | | | | Marcos | | | | | | | A first place to start is IPC's 7711 and 7721 encompasing repair, modification, and rework procedures. | | | |
Electronics Forum | Wed Mar 28 15:47:06 EST 2001 | kerryn
Mike, I see that you are from Aqueous Technologies and you sell stencil cleaners. I now understand your sensitivity to this subject. I seriously doubt that the EPA would copy you on correspondence between the EPA and another company. If they did,
Electronics Forum | Wed Aug 04 16:43:58 EDT 1999 | John Thorup
| We are installing a new reflow oven and I have been told that we do not need to vent the exhaust out through the roof since we have a false ceiling. All that is required is to vent above the false ceiling and that the air exchange is great enough t
Electronics Forum | Sat Aug 22 16:07:31 EDT 1998 | Manuel Cornejo
| | Require a conductive adhesive - either isotropic or anisotrpic - which can be used for 100micron oitch devices. | | Must be resistant to solvents such as MEK and acetone. | | Cure below 150C, with possible potential for rework of the conections.
Electronics Forum | Thu Aug 05 11:27:43 EDT 1999 | Wolfgang Busko
| | We are installing a new reflow oven and I have been told that we do not need to vent the exhaust out through the roof since we have a false ceiling. All that is required is to vent above the false ceiling and that the air exchange is great enough
winsouce.jpg)
