Electronics Forum | Fri Jun 11 08:38:55 EDT 2004 | davef
We figured you were going to say that. Pay me now, or pay me later, you call it. As an alternative: * Cover the backside of the via with masking tape that will take soldering temperature, like Kapon, or a temporary solder mask * Enlarge the apertur
Electronics Forum | Fri Oct 07 11:22:09 EDT 2005 | Rob
Hi, can anyone tell me what the current real price is for a new Fuji XP242E? i.e. the price you can pay & not the price they would like you to pay. I know that there are a lot of other machines out there etc. but it's info on the Fuji I'm after at t
Electronics Forum | Thu Apr 24 13:36:06 EDT 2008 | georgegaytan
Can somebody help me? I have an Ersa Flow 7 but the hard drive from the PC is completely damage. I need a copy of the software in order to get my machine running but I do not want to pay Ersa for all kinds of fees to get a copy. I do not mind paying
Electronics Forum | Thu Mar 01 16:47:05 EST 2007 | ratsalad
The guys that take our dross (and pay us for it) take our barrels that contain scrapped solder paste as well. Also in the barrels are the nitrile gloves and disposable towels used in solder paste handling and cleaning. They pay us for the metal c
Electronics Forum | Tue Mar 25 10:11:03 EDT 2008 | bandjwet
We recently sent some PCB assemblies along with the schematics to a test services provider. Afer paying for the NRE tooling charges we were paying $75.00 per hour for the service providers Level 1 test technicians. Does this sound like a fair rate (w
Electronics Forum | Wed Sep 18 15:41:59 EDT 2013 | cbeneat
For 0402's, if the operator is paying attention, our equipment Panasonic CM 402/602/NPM's run at about .001%. Again this is dependent on an operator that pays attention to the fail rate. We usually don't have too many problems with 0402's, LED's ar
Electronics Forum | Wed Jun 11 16:45:09 EDT 2003 | jgregory
I do not agree. We were even told that if we do not pay, and we need to order parts, that there is no guarantee of receiving the right part number (since we didn't/couldn't use phone support for correct part numbers) and if the wrong part was receive
Electronics Forum | Mon Oct 04 03:48:02 EDT 1999 | Chris May
| What is the average pay that a SMT Programmer would get? The machines would be Fuji and Universal. | This is going to open up a can of worms involving phrases relating to monkeys and peanuts. I have come across a spectrum of scales depending on the
Electronics Forum | Wed Nov 21 14:10:39 EST 2001 | raton
I agree. Machine operators can jimmy up a $150k piece of equipment and get by saying something like 'I didn't know that dropping a scewdriver in doze movin parts would break anyting!' with out more than a token slap on the wrist. However, you're on
Electronics Forum | Sun Sep 15 15:08:00 EDT 2002 | jersbo
My 2 cents... Screen printing may very well have a leg up on deciding SMT defects... however if you pay attention to your stencil (aperture size ratio etc..) and inspect your prints... I believe its a much lesser number... (paste MFG also plays a ro