Electronics Forum | Thu Feb 12 14:26:22 EST 2004 | Kris
Hi all, We have a PCB without any BGAs on it which goes into harsh environment.We therefore conformal coat it. After assembly the PCBs are expected to withstand "85degc/85%RH for 1000 hours" We now want to add a BGA to the PCB. Does any one have
Electronics Forum | Fri Jan 12 06:45:52 EST 2024 | calebcsmt
When conformal coating a PCB, when it comes to components such as alum caps, if no keep-out specified for SMT, would you recommend coating the entire component, or would you only coat the bottom portion (where conductors/leads are present) Moreover,
Electronics Forum | Fri Feb 13 09:17:11 EST 2004 | Kris
we are worried about the coating not being able to cover underneath the BGA. If the coat is excessive then it would cause CTE issues. Also if anybody has data on 85/85, 1000 hrs after conformal coating of BGA, would appreciate if you guys can share
Electronics Forum | Fri Sep 17 03:13:00 EDT 2010 | grahamcooper22
In HASL pcb coating you need to fully coat the pads with solder and then blow off any excess solder to leave a nice coating on each pad. Generally pcb manufacturers try to give you a flat pcb pad to make your solder paste printing more consistent. To
Electronics Forum | Thu May 02 10:25:14 EDT 2013 | wahahasteven
we have a Specialty coating system (SCS) precisoncoat spray coating system. we are using an acrylic coating material with about 80cp viscosity. The spraying pressure is around 4-6 psi. The main issue is the finish looking of the board. If we apply hi
Electronics Forum | Thu May 28 16:10:07 EDT 2009 | operator
How does one keep a pcb safe from ESD when applying an aerosol conformal coating on a flat surface? Even if you had an ESD mat to place the pcb on it would quickly be coated. The only thing I can think of is an ionizer. Does not the aerosol create a
Electronics Forum | Fri Nov 09 13:50:50 EST 2001 | Jim Hammes
Any good advice on techniques to properly coat BGA devices on a PCB? Our preference is to spray the boards but I wonder if the coating will do much good. Thanks Jim
Electronics Forum | Fri May 17 13:33:45 EDT 2013 | bandjwet
How are you removing the remnant cured coating materials once you scrape. laser ablate or use walnut shells to blast coating material from a PCB? We are using a soft bristled brush or a vacuum source. What about liquids such as cleaning solutions o
Electronics Forum | Thu Feb 12 16:57:52 EST 2004 | blnorman
Why can't you conformally coat the BGA? We do on some of our lines with no adverse affects.
Electronics Forum | Fri Feb 13 14:50:57 EST 2004 | blnorman
Underfills could improve reliability. If you pick materials right, you could co-cure and underfill and coating.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
