Electronics Forum | Mon Oct 06 12:37:18 EDT 2003 | ramanandkini
It was a nice discussion. What I did here was a thermal shock test 1 hour@ +90 deg.c and immediately 1 hour @ -40 deg.c. The second test I did was a high humudity test for a week. After each test, I carried out a peel test with scotch tape. Those bo
Electronics Forum | Wed Jan 30 13:45:59 EST 2019 | slthomas
I'm wrestling with the infamous adjustable torque drivers on the production floor. Despite a procedure that clearly forbids it, we still have the occasional know-it-all that will just crank the knob until the desired setting is visible in the windo
Electronics Forum | Fri Jan 15 17:13:07 EST 1999 | Earl Moon
| | | | Hello, | | | | | | | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | | | | | | | So far, the tests I can think of
Electronics Forum | Sat Jan 16 02:43:21 EST 1999 | Earl Moon
| Hello, | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | So far, the tests I can think of performing, and that we have
Electronics Forum | Fri Nov 13 23:33:33 EST 1998 | Kallol Chakraborty
| | | I believe that gold fingers on my circuit boards are being | | | contaminated and need to clean them with some chemical | | | solution. Any recommendations. | | | | | Chuck: What is the type and source of your contamination? Dave F | | We a
Electronics Forum | Fri May 26 04:58:19 EDT 2023 | auriga2001
I agree with the two other replies. Left alone, it is a defect. If it's just excess adhesive or coating, you can use IPC-7711/7721 'Rework, Modification and Repair of Electronic Assemblies' for guidance on removing. Section 2.3.1 explains how to te
Electronics Forum | Sun Oct 10 17:50:00 EDT 1999 | JohnW
| | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almost
Electronics Forum | Mon Oct 11 11:13:32 EDT 1999 | Wirat S.
| | | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almo
Electronics Forum | Sat Nov 14 08:05:54 EST 1998 | Earl Moon
| | | | I believe that gold fingers on my circuit boards are being | | | | contaminated and need to clean them with some chemical | | | | solution. Any recommendations. | | | | | | | Chuck: What is the type and source of your contamination? Dave