Electronics Forum | Tue Dec 06 04:30:16 EST 2005 | rlackey
I was under the impression that the Assemblion/Philips Opal/topaz/GEM/Comet etc were all built in the same factory as the Yamaha machines - all except the FCM's. For the record they have very good support - better than Yamaha in some regions such as
Electronics Forum | Sun Jul 10 13:24:48 EDT 2011 | sarason
I have finally updated my shareware SMT Machine program It reads Protel ( from Autotrax to Altium Designer) and spits out Yamaha/Philips UFOS, VIOS , Mydata, Fuji MCS2 CP642 CP732, Gencad 1.3, Philips, FCM, ACM, FTIP, Essemtec, Panasonic BM221 CM88,
Electronics Forum | Thu May 31 03:12:18 EDT 2007 | vinitverma
Hi John, You can write to me offline at vinit.verma@prosemtechnology.com and write the exact problem that you face after you have generated the action spec using PPS Pro 8.1. What is the problem that you're facing. The coordinate system is taken ca
Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby
The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know
Electronics Forum | Fri Jan 16 19:02:55 EST 2004 | Frank Gearhart - Assembl�on Snr. Software Technical Specialist
The OS/2 software you are referring to is the CSM-PPS v3 which was released in 1999, it is now out of service. The current software for optimizing, balancing, and generating programs for a Topaz and other Gem machines off-line, is GemLine-PPS v8.0,
Electronics Forum | Wed Oct 13 03:38:21 EDT 1999 | Paul Gerits
Hi Morris, I work as a technical consultant, application specialist for Philips EMT (SMT machine suplier). For cost per placement complex calculation can be made. To make a easy one just to hav an idea you can use following. Information needed: Pr
Electronics Forum | Sat Mar 26 14:21:01 EST 2005 | andras
My CSM pop-ups this error after power on: 243 X DRIFT ADJUSTMENT NO GOOD and then latch-up. How can I solve this problem?
Electronics Forum | Fri Dec 22 05:24:23 EST 2017 | protokos
Hi ii is possible to clone a hard disk, but the calibration data must be backup first. if this not can, then the machine must be calibrated.
Electronics Forum | Thu Oct 15 08:06:17 EDT 1998 | Sjef van Gastel
|John, Why do not you consider the Philips Powerline concept ? The Powerline consists of the combination of FCM and ACM. These 2 machines represent the best in class in SMD placement. The FCM can accomodate 96 8 mm tapefeeders, while the ACM can ac
Electronics Forum | Fri Nov 30 00:51:10 EST 2007 | vinitverma
Here are the differences (Eclipse vs Eclipse II) Optimum Speed: 5000 vs 6500cph Feeder Positions (8mm) : 80 vs 94 PCB Loading Time : 4s vs 5.3s PCB Thickness : 0.6-3mm vs 0.5-4mm Max Component Size : 32mm vs 45mm (optional camera possible on Eclipse
