Electronics Forum | Fri Aug 28 14:53:16 EDT 2020 | dekhead
It is not abnormal for the first 2-4 prints to be compensation strokes where the print pressure stablises to its set pressure, ideally the variation is
Electronics Forum | Tue Jul 31 08:29:11 EDT 2007 | stepheniii
If you can, put a pressure tank near the machine. It will help stabalize the air pressure, but only if the compressor is providing enough air in the first place. Throughhole PNP machines tend to take air in big gulps making the pressure go up and dow
Electronics Forum | Wed Jan 11 06:29:47 EST 2012 | cbeneat
We have Vectorguard frames we've been using for about 6-8 months. We've seen no leakage on ours. The frame has written on it an operating pressure of 101.5-116.0 psi,our pressure is set a lot lower, 50-60 psi, as we also use another frame that can'
Electronics Forum | Tue May 22 08:23:55 EDT 2018 | dleeper
metal blades scraping against a metal foil; do it enough times and any stencil will look like that. It's possible the squeegee pressure is set too high, exacerbating the condition. Try reducing squeegee pressure a little at a time, making sure you
Electronics Forum | Tue Jul 09 07:35:48 EDT 2019 | stephendo
Watch the air pressure gauge and make sure you have a good steady air pressure. I don't know about the Rad 5 but the Rad 3 was sensitive to fluctuations in air pressure. By any chance do you have a VCD running nearby when you are having the problems?
Electronics Forum | Mon Nov 11 21:44:06 EST 2019 | kylehunter
> Knead pressure, is normally at or slightly lower > (maybe 25%) than print pressure... Ahh makes sense. Couple other quick questions if you don't mind: 1) Currently do kneading after 15 mins of no activity, with 3 knead passes, is that n
Electronics Forum | Thu Aug 27 14:32:34 EDT 2020 | dekhead
Following a pressure error, if continue is pressed, the next print with THE CORRESPONDING squeegee should attempt to compensate by increase or decrease in pressure (as appropriate)... Is it: 1)Not changing at all? 2)Over compensating? 3)Under compens
Electronics Forum | Fri Feb 29 08:27:34 EST 2008 | tbkonrad
This morning I turned on our Qsv-1 and ai resiveved the following error. "Clamp did not open: House Air pressure may be lower then 70 psi" after checking the Air Pressure it reads at 80 psi on the Main air pressure gauge as well as the 80 psi on the
Electronics Forum | Thu Jan 12 20:11:25 EST 2012 | davef
Isola water pressure. Between a 210°C normal tin lead cycle and a 250°C lead-free assembly cycle, the vapor pressure doubles. Reflow temperature [*C]||Vapor pressure of water [psi] 150||100 200||225 210||260 220||320 230||400 240||480 250||580 300||1
Electronics Forum | Thu May 02 10:25:14 EDT 2013 | wahahasteven
we have a Specialty coating system (SCS) precisoncoat spray coating system. we are using an acrylic coating material with about 80cp viscosity. The spraying pressure is around 4-6 psi. The main issue is the finish looking of the board. If we apply hi