Electronics Forum | Tue May 06 11:14:40 EDT 2003 | k_h
Sorry, I did misunderstand. My opinion would be: Assuming nothing else used feeder space, like tray changers, camera's, nozzles, ..... and assuming 1 slot = 1 8mm feeder position, I think 70-90 slots would be reasonable. A reasonably priced feeder ta
Electronics Forum | Wed May 16 13:40:19 EDT 2007 | slthomas
"I read a study a while back by IBM that showed too strong a vacuum would cause too much moisture to enter the bags." That's what the nitrogen is for. If you pull a vacuum w/o backfilling with something dry, like nitrogen, pretty soon the vacuum ove
Electronics Forum | Wed Sep 15 12:22:51 EDT 2010 | remullis
Mike, Another thing to consider is the type of switching they may use. Older Asymtek masking machines used transitors to communicate upline and downline instead of dry contacts. The problem we had with this is dropping enough voltage across them to
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Thu Mar 21 15:36:19 EST 2002 | slthomas
We're having trouble with a TO-252 DPAK from Fairchild (MC7805CDT) and our existing land pattern. The land pattern calculator on the IPC site doesn't have anything available that matches it (there are no TO-252's available on the pull downs), and I'
Electronics Forum | Tue Jan 13 18:29:35 EST 2004 | Tom B
I agree with Fastek. Universal tooling is the way to go if you got high changeover. Another option is Grid Loks support system (http://www.grid-lok.com/) Basically remove the ztower and add this system. It'll cost ya about 10K. Get board snugge
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Wed Mar 29 16:25:55 EST 2006 | Tech
Find you a good degreaser to clean the clutches with. Fuji used to ship Threebond with the machines but quit due to negligence on the part of the users if I had to guess. I believe the number was Threebond 2706. Now make sure you take a shop rag or s