Electronics Forum | Fri Apr 05 20:00:08 EDT 2013 | microaide
I cheated on the escapement length for the SOLIC plate and got through Feeder Optimization and Generate Program without any errors. Some progress, but no I cant figure out how to the the generated program into the central controllers on the Quad IVc
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Wed Apr 10 15:05:23 EDT 2013 | microaide
I followed your instructions and did NOT select the option to break up the program for separate central controllers. I now have a program I can copy to central controller #1, and I can delete the head 2 data from the program. Now when I select RUN TH
Electronics Forum | Mon Sep 30 15:26:48 EDT 2013 | leemeyer
I have been using Quad 4C's for 15 years and have never come across this error. Everything initializes OK but when I start a program through Central Controller I get an "OUT OF MEMORY" error. I have flushed the Mod codes and re-entered them and have
Electronics Forum | Sun Dec 04 10:40:23 EST 2011 | bobpan
Do you have the motor power turned on? It is next to the main power breaker (front panel of machine). Are all the covers down? Are the side covers pushed all the way in? What is the led status of your driver cards? They should be all green with no re
Electronics Forum | Thu Jun 30 13:49:15 EDT 2011 | jholif
I am seeing a motor error 4 intermittently during operation. Sometimes it happens as soon as a program starts, sometimes it will perform 1-6 placements and then stop with it. I have swapped the stepper motor driver cards, the EPCU card, the SRX card
Electronics Forum | Tue May 10 09:45:53 EDT 2011 | veeckm
After changing mod codes 50,51 and 54,55 respectively on the HHT I will then goto ccconfig.sys file in the central controller software and manually enter in the new mod code values. I do not do any uploading/downloading of mod codes through database
Electronics Forum | Mon Mar 21 22:09:28 EST 2005 | dlkearns1
Did you get your answer? From all the reading I've done since your posting, does this issue happen when running a "specific" program or any/all programs ? Just a thought, as MOD codes can be tricky. Also check the thru-holes on that backplain conn th
Electronics Forum | Wed May 01 15:27:22 EDT 2013 | lheiss
Hi All, I've been using a IVc for many years. I'm to the point where I have Mod Code 8 = 15, MC9 = 500, and all Extents PU delays set to 40ish. These settings work pretty well but I would like to get them closer to factory defaults to save the los
Electronics Forum | Wed May 04 21:32:30 EDT 2011 | jimlas53
Thanks for the answer, RLM, I couldn't find anything in the manual that was helpful. If I use a common extent for each component type, I need to identify those components that may be turned due to the feed type (tape, vibe). Is this where I would d
