Electronics Forum | Mon Feb 23 14:58:01 EST 2015 | ercdave1
I found the solution to my problem. Since I don't have a manual for the machine. I had no idea how to change the system settings but by pressing the first 2 buttons on the left of the front panel I got the system settings menu and was able to change
Electronics Forum | Mon Feb 08 15:54:22 EST 2021 | bobpan
I think in the machine configuration there is an option to use the vacuum or not. Its been a long time but i think you just just skip past the vac message if it pops up. Pust both left buttons at the same (under the display) time to get into the mach
Electronics Forum | Tue Feb 09 10:01:08 EST 2021 | bobpan
1. The resistor is normally hot. 2. If the machine is crashing towards the front then the system settings need reset. Do this by pressing and releasing the e stop then pressing both front left buttons on the mylar below the lcd screen. Go into the ma
Electronics Forum | Thu Mar 04 14:55:48 EST 2021 | mendez
Thanks a lot! I sent the boards to REPRINT in UK, and I'm waiting to get them deliver to do the final testing. Are these printers very reliable? I heard that if you have the stencil cleaner (my has) to avoid using it since it was a bad design and bu
Electronics Forum | Thu Mar 04 15:11:45 EST 2021 | mendez
Thats good to hear. I have (1) extra boards for the LCD and the Motion drivers in case something gets damaged later because as you mentioned; parts are very difficult to find (or super expensive) I did soldered the IC chip on the LCD unit and get RE
Electronics Forum | Sat Feb 06 15:47:01 EST 2021 | mendez
Hello, I'm new to this forum. I recently purchased a 100MV Screen printer and unfortunately; it arrived damaged. I was able to turn the unit on and I was able to get the unit do the initiation process (ex. datums). When I tried to do a sample PRIN
Electronics Forum | Thu Mar 04 15:01:32 EST 2021 | proceng1
We used to have 5 of these in service and they worked great. Only 1 had the stencil wiper, and we did not utilize it. We've since installed all inline printers, but we do keep 1 MV100 on the floor as a back up. The firmware can get squirrely and the
Electronics Forum | Mon Feb 08 14:29:20 EST 2021 | mendez
Great. I just send them an email; I appreciate your support. Quick question: I found it odd that the printer seems to be working fine when I turn it on for the first time. But as soon as I push the two "PRINT" buttons, a window of VAC came up and th
Electronics Forum | Mon Feb 08 23:16:07 EST 2021 | mendez
Hi, so I was able to turn the machine on for a few seconds. It looks like the IC on the LCD doesn't have goo contact because it's very hard to keep the machine operational. I was able to see the table lifting for the first time; it was so cool! but t
Electronics Forum | Wed Nov 03 16:35:03 EDT 2021 | smtusa
We are big mpm fans especially the UP2000/2500 dos based. I just got an MPM SP2000 but feel thats too big. I would like something even smaller for an office setup. I looked up the MV100 and it came up with a pic of Quad. It looked pretty big in p
