Electronics Forum | Mon Feb 12 09:44:47 EST 2007 | SWAG
Enhanced board set-up, set conveyor width, load board, (your fiducials must be accurate!), use two fiducials to set reference point, click on placement(s), move crosshair to centerpoint, use two point teach to teach one point in the center or use cor
Electronics Forum | Fri May 18 06:21:05 EDT 2007 | aj
Hi, We did this last year and winded up having to replace one of the contactors due to the frequency of up/down,up/down. Not sure what implications the constant on/off would have on the alloy after a while/ dross etc. When your pot starts up that
Electronics Forum | Thu Mar 03 09:20:35 EST 2011 | scotceltic
Thank you for the responses. Since my post I have worked with our Bartector software developer to come up with a nice setup that will save us approximately 60% of our previous sorting time. Basically with a minimal setup of 5 minutes or so I can now
Electronics Forum | Mon Nov 16 09:32:54 EST 2015 | henrikk
I am about to disassemble a Fuji CP4-2 chip shooter machine and I was wondering what are the most valuable parts that I should save and maybe put up for sale. Unfortunately I do not have a lot of storage space, so I have to throw many of the bigger p
Electronics Forum | Fri Sep 09 06:03:37 EDT 2016 | jswatt
Simple answer is no you cannot do it and why would you?.. is it a cost saving thing? As Dave F correctly points out you have a fair amount of noxious fumes to handle that aren't getting exhausted if you switch of the extraction so they will go to you
Electronics Forum | Thu May 04 14:25:27 EDT 2017 | sumote
In a previous job we had DEK cut our stencils. If you are not already using the Vector-Guard system it is very nice. It saves $25 (or at least at that time it did) per stencil, but the really nice thing is the space savings. You can store several ste
Electronics Forum | Mon Oct 01 15:18:01 EDT 2018 | SMTA-Shafiq
Hello All, I'm looking at performing a cost analysis to calculate cost per placement at SMT. I've read articles and many suggest simplifying it to labour cost (hourly rate x # of operators) / # of placements per hour. Other angle to this is evalua
Electronics Forum | Fri Nov 02 19:34:19 EDT 2018 | sarason
I am assuming that your application is Automotive. The logic here is that the product has got to at least run for 8 years or more. The prebake removes any moisture that may creep into the product during the wait time. A little moisture combined with
Electronics Forum | Tue Mar 16 17:34:27 EDT 2021 | dan_ems
Hello, can you help please with a question regarding Fuji NXT programming? During the placement of the components on the fuji interface the image of the components during alignement can be seen on the Fuji operator interface. My question is can be al
Electronics Forum | Wed Mar 08 21:21:23 EST 2000 | Dave F
Charles: Interesting. Best laid plans, eh. Why don't you throw those pups into a glass of water and save some air freight? Or have you decided that shipping 'em is cheaper than buying the Altos? ;-) Ta Dave F