Electronics Forum | Fri Mar 09 15:18:51 EST 2007 | Mark
hello, try to redesign apperture:- cross-hatched with 0.5mm or 1.0mm web according to pad size mark
Electronics Forum | Wed May 02 08:59:30 EDT 2007 | Mario
Hello, What could be the cause of the skewed mounted LXHL PW01 kinds of POWERLEDS? Is the bad recognition (although detected sucessfully)or the machine is uncalibrated? The machine used is Eclipse II from Assembleon. What workarounds can be made to
Electronics Forum | Thu Jun 14 14:45:45 EDT 2007 | shrek
Well, whether your parents like it or not, I am an ogre! And guess what, princess Mika? That's not about to change. Princess Mika, all joking aside, the parts placed by my CP6 are billboarded, skewed, and mismounted in the lower left corner of th
Electronics Forum | Thu Nov 08 10:14:43 EST 2007 | slthomas
"Their third attempt was a report that Process Engineering was being resistive and skewing the tests." Thanks for the early a.m. laugh. I needed it.
Electronics Forum | Wed Dec 07 15:54:28 EST 2011 | comando
this bulbs never have been replaced but the image look ok I would like send you a part placement image and i don't know how , if you want send me you e-mail to send the image
Electronics Forum | Wed Oct 18 15:35:11 EDT 2017 | jdprecise
I have an issue with CP4 seeing FIDs but not correcting placement according to new skew angles. Fids in the sequence are linked accordingly. I suspect, it has something to do with the inspection method of the FIDs. SCAN or LEVEL Any Thoughts?
Electronics Forum | Thu Dec 14 11:49:37 EST 2017 | barryg
When the board is populated on the second side, and after reflow, components are shifted, skewed with solder flowed on the leads of the components and not on the PCB land.
Electronics Forum | Fri Aug 24 08:49:54 EDT 2018 | davef
My first guess at the cause of your components skewing -- Termination pads on the board to not well match the the soldered terminals on the components, causing unbalanced wetting forces on the component terminations while the solder is molten.
Electronics Forum | Thu Aug 01 13:15:52 EDT 2019 | davef
if the inductors were your only problem. My mom wouldn't be pleased with the V30200C dual voltage rectifier just below the inductors
Electronics Forum | Thu Aug 01 14:18:35 EDT 2019 | huske
Looks like you have too much solder, looks like is balling out of the side of your pads.