Electronics Forum | Fri Jan 29 11:23:54 EST 2010 | ppwlee
Smtnet, I am looking at pros and cons for automated soldering. The application is a simple multi pin through-hole soldering on a high volume manual assembly line. The goal was to eliminate defects associated with missing solder pins which goes undet
Electronics Forum | Fri Apr 12 15:48:33 EDT 2002 | jersbo
SPC for each assembly(I use C(for board defects)NP(for unit defects) at the end of reflow to determine process capabilities determine Control limits. Once control limits are set, inspectors stop the process until out of control limit is addressed and
Electronics Forum | Mon Apr 17 22:54:51 EDT 2006 | Darby
Short answer is - not really. According to the manual in Chapter 1-5 Supply devices (Feeders) overview "There are also available an 8mm tape feeder which handles 1005(0402) square chips". I have never seen one. The problem is that even an H nozzle is
Electronics Forum | Sat Sep 23 21:52:51 EDT 2017 | jlawson
In most cases PnP files are all that is needed for SMT program generation. BUT, it depends on origin reference of this data as exported to PnP and could be off in X,Y and rotation of image pending when PnP Data is exported. Also Rotation of parts
Electronics Forum | Tue Apr 09 16:25:28 EDT 2002 | clarkk
Alan, You're right, mass inspection after assembly won't work. The inspectors will miss 25% (or more) of the defects, and the boards will be reworked before SMT operators can properly define defects and their sources. The company I work for tends to
Electronics Forum | Tue Jun 19 12:26:38 EDT 2007 | billr73
We will be hand soldering a small number of PCBs per week (both through hole and SMT) using a water soluble flux. We will be using both standard leaded and lead free solder. The completed assemblies be hand washed in a sink using hot water. Do we
Electronics Forum | Mon Oct 29 20:19:44 EST 2001 | davef
DON'T do it!!! The two problems you'll have are: 1 Poor manufacturing process control, resulting in weak solder connections. 2 Weak solder connections are stressed, when the board is straightened upon installation in the "box". There's several hits
Electronics Forum | Mon Oct 03 12:11:18 EDT 2005 | PWH
Soon we will be manufacturing board assemblies on our SMT lines that will utilize both lead and lead free water soluable solder pastes. I have read some discussion about change-over from lead to lead-free jobs related to machine cleanliness, etc. H
Electronics Forum | Sat Sep 29 19:04:13 EDT 2012 | e_music
Hello, I have just installed the demo version of GC-Powerplace. Could anyone here walk me through the process to generate pick and place file from gerbers? I don't have solderpaste layer. All I have got is signal layers (top/bottom), soldermask, sil
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694