Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Wed Dec 30 14:51:50 EST 2009 | gantry
Craig - It has been quite a while but from what I remember you teach the tray holder in teach table top. Then you have to put the part/tray on the the tray holder. Also, ensure the part is in your program. I don't remember where to do that but I
Electronics Forum | Tue Mar 30 05:27:06 EDT 2010 | accuspares
Hi, Can you tell me at what point in the print cycle the error happens and if it consistently happens at the same point? The machine has two crash beams running down either side of the machine as a safety measure to ensure the table is down before
Electronics Forum | Fri Apr 30 07:39:54 EDT 2010 | jdengler
We do a similar part on a Fuji IP3. Set table speed to low. I do not know the QP, but if it's similar to the IP make sure the board clamp/unclamp is smooth. On our IP it got dirty and was jerking causing the board to jump a little which bounced ou
Electronics Forum | Fri Jul 09 19:20:49 EDT 2010 | rway
This table, is it in a database? And is it indicating the number of component, solder insp. etc based on one board or one panel? It needs to be based on the total number of inspection on your panelized pcb. The equation works, you may just be look
Electronics Forum | Tue Dec 28 03:59:06 EST 2010 | riscy00
I'm investigating heat transfer by 1st order approximation between PCB and ambient air via encapsulate material (epoxy or gel or silicone), they have thermal conductivity of 0.2W/C but it hard to find specific heat capacity and density. Has anyone
Electronics Forum | Fri Feb 24 07:28:11 EST 2012 | duso02
If you are going to coat very low volumes then just spray it by hand. The automated machines just won't be worth it unless you are going to do a very large run. They are complicated, require constant attention, still require masking the board and are
Electronics Forum | Fri Feb 24 08:02:22 EST 2012 | cobham1
Our production runs normally are 20 piece builds. We don't what to brush because of the brush marks left behind. Reason we wanted a machine is more control then dipping with a tub and modified paper clips. The other problem we have is the company as
Electronics Forum | Sat May 12 01:46:19 EDT 2012 | miulius13
Hello guys, I hope this thread is located properly! I have few designs made in OrCAD Layout and I need to switch them to automatic assembly but I've been told that I need pick and place files for them ... hence my request for you: How can I export t
Electronics Forum | Tue Jun 05 03:06:56 EDT 2012 | eniac
Yes, I have experience with table model of ScanSpection. Machine work fast, but process of job program making is very slowly. If you each time have elements from one supplier - this machine for you. But if you have many suppliers of components - it's
