Electronics Forum | Fri Feb 16 11:37:58 EST 2007 | hectorsmtnet
I have been using the Loctite Multicore WS200 with great results for the last two years. We also use the lead free version WS300. I like the flux chemistry (which is the same for both products); it really withstands long soaking times and with very g
Electronics Forum | Thu Mar 30 08:38:58 EST 2006 | Dan
We have this panel that is Gold Flash. Am I correct in assuming this is technically a lead-free panel then? We are running a WS paste, and the QFN28 has balls of solder instead of a fillet. My Max temp is 216, and the TAL was between 52-57 secs with
Electronics Forum | Thu Apr 20 07:53:24 EDT 2006 | Yanick
Hi, I'm just wondering if someone have more information about board with immersion tin plating. I search in the archive but didn't find anything interesting. We try it, and we have difficulties to make a good solder joint with the wave. And wi
Electronics Forum | Wed May 24 16:40:40 EDT 2006 | samir
Yikes! Sounds like a hairy situation there. I've successfully collapsed a Pb-Free BGA (using a Sn/Pb solder paste), with a peak temperature of 220 Deg. C and Time Above SAC's Eutetic point (217) of 17 seconds. Beware of overcooking your smaller ma
Electronics Forum | Fri May 26 14:15:16 EDT 2006 | patrickbruneel
Its it possible to post a picture from right after reflow? To see what we start with and compare the difference after 5 years. The grainy structure is not as much a concern as the growth-like appearance on the boundary of the solder. What paste al
Electronics Forum | Wed Jun 14 21:49:42 EDT 2006 | davef
Bryan: * Most of our stencils are made from stainless steel that is held by a aluminum frame, attached with epoxy with a fiber glass intermediary between the frame and the stencil. * We use stencils to print either glue [thermoset epoxy] or solder pa
Electronics Forum | Tue Jun 20 10:26:07 EDT 2006 | samir
Chunks, I used to work in power electronics, and we had this design engineer who used to "blow moisture" on the high-impedance circuit and test for cleanliness. We were water washing in a OA-Water Soluble environment. He was convinced that there w
Electronics Forum | Fri Jun 16 18:52:03 EDT 2006 | grantp
Hi, Reliability was what I was worried about. We have not shipped these yet, as we are not sure about reliability. We can ship them in regions outside of the EU anytime so we are ok on that, and because of supply chain delays, we are already shippi
Electronics Forum | Fri Sep 08 10:16:24 EDT 2006 | slthomas
We had problems with Panasonic film caps with a previous employer. The first step was to use their recommended pad layouts rather than industry standards for the part sizes. The second much more helpful resolution was to complain like hell to Panaso
Electronics Forum | Thu Oct 05 15:58:16 EDT 2006 | RusH
Mario, Thanks for your response. We are building a leaded assembly with hot air leveled Sn/Pb pads on the PCB. In one case the component is a 7.5X5.2X1.8 wire wound ferrite inductor with Au/Sn leads. The second component is an 0808 Tantalum cap,
Capital Equipment Solutions - SMT | PCBA | TEST
Equipment Dealer / Broker / Auctions
113 S Main Street
Lodi, USA
Phone: 6083431779