Electronics Forum | Fri Aug 02 11:48:23 EDT 2002 | johnw
I can't think of any off hand other than the Ersa which is massive and from when I used it a pain in the A*SE to program and keep programmed, you always seem to have to baby sit it. I bet if you asked you could get one, the problem is that forced con
Electronics Forum | Fri Aug 09 17:13:50 EDT 2002 | Antonio
Hi Guys, Just would like to inquire about contract manufacturing costing: a) if I send my bds. to a CM with a line of 2 chipshooter and 1 IC mounter and will use only 1 chipshooter and the ic placer for my product, do they need to charge me with th
Electronics Forum | Tue Aug 13 20:57:01 EDT 2002 | davef
We don�t use this glue. What does Heraeus say about your condensate? [I'm With the previous poster. Your condensate sounds like goop from NC flux not glue.] How to clean out a 3 meter length of chimney? Depends on your tolerance for pain * Take
Electronics Forum | Tue Aug 13 13:17:39 EDT 2002 | peterson
We are having trouble with some through-hole connectors "shorting out" on a thick backplane. Preliminary research is suggesting that it may be due to excess flux, trapped under the plastic connector shell. I have done a bit of searching in the fine S
Electronics Forum | Tue Sep 03 17:48:34 EDT 2002 | dphilbrick
My customer is finding a blue haze on some SMT pads after processing, kind of looks like a water spot on the surface of solder joints. It requires 20x mag and very good lighting to see. We have done 2 different ionic tests and the boards pass to clas
Electronics Forum | Thu Sep 12 15:58:02 EDT 2002 | stepheno
It's been years since I worked with a Fuji. I only once resorted to the undocumented part class 255 (or whatever they call it) and that was when I was working midnight shift. The smaller nozzle working better than the larger nozzle makes me wonder a
Electronics Forum | Fri Sep 13 13:26:34 EDT 2002 | dougt
If it's not blowing the fuse in the car then I guess it wasn't drawing a huge amount of current. Check the power wires going into the radio and look for something loose. My first guess is your loosing voltage across a bad connection somewhere and a
Electronics Forum | Sat Sep 14 01:34:19 EDT 2002 | Yngwie
I have the following questions on Via in Pad and want to understand each of them wrt : - complete Via in pad - partial encroachment - via partially in pad 1) What is the general feel for via in pad for upcoming designs? 2) What are the manufacturi
Electronics Forum | Tue Sep 17 00:40:39 EDT 2002 | yngwie
Hi all Experts, Desperately need your help on the following questions on Via in Pad and want to understand each of them wrt : - complete Via in pad - partial encroachment - via partially in pad 1) What is the general feel for via in pad for upcom
Electronics Forum | Wed Sep 18 16:56:55 EDT 2002 | stockley
I started writing a long winded explanation about SMEMA and realised that it is just as easy to write about this as it is to talk about it on the phone. It just so happens that I have recently gone through this process so I believe that your vendor