Electronics Forum | Mon Jul 18 01:23:23 EDT 2005 | Cal
In regards to your post...I am sure Autotronk is the manufacturer. I can only asume when you speak of a "local Rep" it is in the US. If you go to Autotronik's website via the link you provided...you will see Manncorp is the Canada/USA/ Mexico Rep. He
Electronics Forum | Mon Jul 18 16:58:31 EDT 2005 | Gpe. E
Hi everybody. I would like to know if any of you guys is using the HP5DX output processor from Assembly Expert to generate de .NDF files for the 5DX machines. I tried but I got a lot of errors because de configuration file for that processor needs
Electronics Forum | Wed Jul 20 17:04:39 EDT 2005 | pjc
Would you risk your equipment decision on the �opinions� of a small select group of others? I have found this to be the most incorrect way to compare machines. Reason is, you always have two camps, and most have different experiences and applications
Electronics Forum | Tue Aug 23 13:25:10 EDT 2005 | MMurison
MUAnalysis is an independent lab for Component Failure Analysis and Reliability Testing in Ottawa, Ontario Canada. We also would be pleased to discuss your analysis needs. We also perform all non-destructive testing, e.g. visual, x-ray, C-SAM, el
Electronics Forum | Wed Jul 20 10:07:05 EDT 2005 | cecil
Does anyone have any input on the need to bake out an assembly prior to the conformal coat process? I understand baking out components/pwb's prior to processing through the reflow or wave solder process if the material shows excess moisture absorbtio
Electronics Forum | Mon Aug 01 18:50:46 EDT 2005 | crishan
Hi Cecil, We using conformal coating in our manufacturing area, we did use to use Humiseal, others have been Bectron and Peters. We recentalt switched all lacquering to Peters, since it is lead free and it is a lot friendly than Humiseal. To answer
Electronics Forum | Wed Jul 20 13:47:42 EDT 2005 | russ
IPC has this. I cannot remember which one, Here is what I do for a quick reference. square pin - add .015" to the pin dimension e.g. .025" square pin gets a .040" hole. OR if the pins are large get the max dimension )e.g. a .025" square pin has
Electronics Forum | Wed Jul 20 15:05:28 EDT 2005 | Fred M.
With the new rev D release of IPC-A_610 came a new section 10.2.9.3 which identifies a via (through hole) with nicks along the inside of the annular ring. Defect is all three classes and states "Damage to conductor or lands". We have for years defa
Electronics Forum | Thu Jul 21 14:05:19 EDT 2005 | cyber_wolf
Dave, I think I worded my post poorly. I am not sure if "tuning fork type" is the correct terminology. The instrument I am looking for usually has a hand held unit connected to a device that resembles a small tuning fork. As a matter of fact, I thi
Electronics Forum | Tue Aug 02 23:02:04 EDT 2005 | crishan
Assuming it is not PCB supplier related, here are my thoughts; 1. CHK Component density top / bottom, I am assuming you do bottom reflow first then top. If have alot of heavy comps on bottom it might cause the board to sag in the middle. 2. You hav
