Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Tue Feb 15 19:24:28 EST 2005 | Alan
I have also seen this before on a CP6. We had an issue once on a CP where the shaft was coming down too far at stn 1 for pick up and forcing the nozzles up and sticking in the windmill. Check that the correct spring type is being used. Also, maybe
Electronics Forum | Mon Mar 07 18:41:13 EST 2005 | jimmyb
--IE, Funny.--- I "remember" kinda, from the early CP6 years, things about the springs. The early Fuji springs had sharp ends, and if you spun the nozzle, prior to final attachment, the opposite way it could stick, and if it was spun the right way,
Electronics Forum | Thu Jan 26 10:36:22 EST 2006 | fredc
My mistake it was tip #2. I am not sure about Fuji's price now, but our rettips were about 1/3 the price of new. The cost difference between our new and our rettips is only two or three dollars depending on quantity. There was a time when the cost d
Electronics Forum | Mon Feb 21 13:57:37 EST 2005 | JB
Start by verifying the component definition, the thickness is critical. HSP 4796 uses nozzle 81 for 0402's. Make sure is using the right nozzle. If you need to, use the autoteach function to physically teach the dimensions of it, thickness included.
Electronics Forum | Tue Feb 15 18:09:45 EST 2005 | GS
Hello everybody, according to your experience, what is the allowed or suggested (by Suplliers,or Standards,or best pratics) shelf life for components (SMD/PTH) from fabbrication date to the soldering date ? Let's consider best case when compon
Electronics Forum | Wed Feb 16 08:15:32 EST 2005 | GS
Thank you Dave, that is almost the asnswers we use to give to our Customers when auditing they ask for component shelf life. But as you can imagine, they whant to see a quick information right on the label (on Reels, on trays, etc) like: Use b
Electronics Forum | Wed Feb 16 12:34:49 EST 2005 | greg
Hi all We recently have a problem with component in package 0805 (capasitor 100nF). I have noticed that after reflow soldering only one lead of the component is soldered. The second one is just laying on the PCB land. We use screen printing process
Electronics Forum | Thu Feb 17 15:01:23 EST 2005 | davef
We're not familiar with your DYMAX #984-LVUF. The problem is not with your conformal coating. The problem is with your 0805 [and not all of 0805, probably just those from a specific supplier]. This lack of coverage of components is called dewetting
Electronics Forum | Sun Apr 10 03:25:35 EDT 2005 | Peter
Normally, some conformal coatings do not have very good wetting properties, that should be basic function of a good coating material (the same reqirement as avoid bubbles during coating process)! For UV curing conformal coatings, you can try Lackwe
