Electronics Forum | Thu Sep 27 16:21:03 EDT 2007 | adlsmt
We have two, about 2.5 years old and 1.5 years old. We run all kinds of parts and get about 18K to 20K CPH. The pick accuracy is fantastic so have saved a lot of $$$$ by not having dump buckets full of parts at the end of runs. I could not be happier
Electronics Forum | Fri Sep 28 18:16:21 EDT 2007 | hegemon
Replacing Screen Printer with a dispensing system? If you have large complex PCBs you will lose a bit of time to say the least. That being said, we have had great success with an I&J Fisnar 'bot with positive displacement (auger) valve for dispensi
Electronics Forum | Fri Oct 05 21:29:43 EDT 2007 | mika
Hussman, I don't understand the last sentence of yours "but far from where this thread was going". What do you mean with that? I was just trying to give "Novaman" some infos. The fine old equipment You use from the old -20:s or so, is probably just a
Electronics Forum | Fri Oct 12 14:53:56 EDT 2007 | mika
Hussman, I'm sorry that I was a little bit tired and on top of that not so sensitive to your humour. Not so easy to understand everything for us Swedish guys. We have normally a great sense of humour over here and almost daily we have a big laughs a
Electronics Forum | Tue Oct 02 09:01:08 EDT 2007 | rgduval
Peter, Need a new hire? I'm up for moving . Considering the size...I'd guess that DBA or something similar is more along the right lines for you. xERP (Manex) may be way more than what you need. We were using it in a $20 mil company, and had a l
Electronics Forum | Tue Oct 02 10:08:20 EDT 2007 | allgood
Well apart from us being in the UK and I suspect you are over the pond, you wouldnt want to work with me for what I can pay! I am looking for a partner though......! We do punch above our weight already in that we must be Aegis's smallest customer
Electronics Forum | Fri Sep 28 16:49:48 EDT 2007 | davef
good * No IMC => bad Intermetallic growths are diffusion limited, and therefore the thickness of the intermetallic is given by: z^2 = (Do)(t)exp[-Q/RT] Where Do (m^2 s-1) is the diffusion coefficient, T(�K) is the temperature, Q (J mol-1) is the act
Electronics Forum | Wed Oct 10 14:21:04 EDT 2007 | petep
We have done the Green Framed Stencils for an added $50.00 per, then got smart and went to green polyester on RoHS / Lead Free Stencils at no added cost. Dedicated Stencil blades and holders green of course) as well as Green Static mats on dedicated
Electronics Forum | Thu Oct 11 14:56:27 EDT 2007 | chef
Thank you- my point exactly and it starts in SMT- operators pulling the wrong paste from the fridge, touch up using the wrong solder wire, etc. My solution- GET THE LEAD OUT!!!!! I'm a CM- high mix, low to medium volumes. No steady all day every day
Electronics Forum | Fri Oct 12 14:46:56 EDT 2007 | chef
All- good points and to be clear not all is in fun and jest. I support ROHS for the environmental issues. Get the lead out is my mantra, there's alot to consider for sure. I prefer to migrate that way, in time. Most my jobs are ROHS already, just a f
.gif)
