Electronics Forum | Wed May 09 09:54:01 EDT 2012 | swag
We build all our stuff in "kits" as you describe. We don't have much trouble running short on parts at the end although most of our equip. is new which helps a lot. We also have feeders that can run in reverse on set-up stations and we reload parts
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
Electronics Forum | Wed May 09 05:54:51 EDT 2012 | pvasquez
Hello thomas31, When we did our equipment evaluation, we looked at all of these systems with the exception of Goepel. My team and I thought that the image quality of the Mirtec machine was by far the best of any of the other vendors. We also found t
Electronics Forum | Wed May 23 08:39:37 EDT 2012 | tony_d
Thomas, We evaluated several AOI machines and narrowed the field to two, YESTech and MIRTEC. We had an opportunity to work with both of these machines on our production floor. In our experience, the MIRTEC machine simply outperformed the competitive
Electronics Forum | Fri May 04 13:42:11 EDT 2012 | spoiltforchoice
The Manncorp machines are Autotronik machines re-branded. These are Chinese built while pretending to be German, they are seemingly capable enough and do come in at very attractive price points. The FLX from Essemtec is in many ways a slicker machine
Electronics Forum | Sat Aug 03 03:26:26 EDT 2013 | sarason
I have had some experience with both Manncorp specifically the 7722 machine and the Essemtec 7100. Both machines are supported in my software PCBSynergy. http://members.iinet.net.au/~sarason/ The service from Manncorp for my friends machine after s
Electronics Forum | Mon Aug 05 10:06:41 EDT 2013 | stevevb
Hello Scotty, As a CM, your first process should be new. We bought a Quadra P&P centric line to build our solid state relay products and loved it so much, we (VB Controls) became a TWS Automation distributor. Recommendation: 2700 semi-automatic s
Electronics Forum | Mon May 07 16:07:05 EDT 2012 | davef
Start with targets based on the stencil thickness (for height) and stencil thickness times the aperture size (for volume). * Set reasonable upper and lower control limits (+ 25% and –25 % of the targets, for example). * Next, check the printer set-u
Electronics Forum | Wed May 09 03:13:06 EDT 2012 | umar
I had send my coating board to the test lab for adhesion coating test. 3 times send, the result 3times fail. The coating chemical use is Humiseal 1B31. The process is clean the boards at washing process use the Vigon A200 saponifier mix with DI wate
Electronics Forum | Sun May 13 02:08:26 EDT 2012 | isd_jwendell
In testing 63/37 SnPb NC paste I have seen HUGE differences in performance. Have you tried a different paste? I prefer AIM (NC257-2), they have performed well in each round of testing. My observations regarding mixing old and new paste: The paste ha