Electronics Forum | Fri May 02 12:54:55 EDT 2003 | Chris Lampron
Hi LWEI, This is not a permanent fix for the problem. We have had similar experiences with double sided boards. As a fix, we have applied water soluble solder mask to the edges of the component. This holds the component adequately for second side pr
Electronics Forum | Thu May 01 09:02:55 EDT 2003 | ehess
we have used board mask that we let dry. It's tricky to get it flat with no spikes, but after a few tries you'll get it. I like the guys recommendation to try paste and let it dry. we have that problem when the operators do not clean the stencil p
Electronics Forum | Wed May 07 09:02:29 EDT 2003 | cyber_wolf
I was wondering if anyone has done a study on thermo couple attachment with light cure adhesive.I have read all the papers and articles about aluminum tape, Kapton, and high temp solder.I have yet to hear anything regarding the accuracy of light cure
Electronics Forum | Mon May 19 02:59:04 EDT 2003 | emeto
Hi, I can give you a few steps. 1. The solder paste. Take the profile that manifacturer gives for the paste. 2. Use termocouple to measure the tempereture. Put PCB and measure the temperature in equal terms. 3. Compare your profile to manifacturers
Electronics Forum | Sat May 17 02:13:43 EDT 2003 | Hon Choi
Thanks all. We are using no clean, so the boards are not washed. That would eliminate the trapped water issue. We would check the PCB after dismounting the BGA, and the short would not be found. When we place another BGA on the board, the board w
Electronics Forum | Mon Jun 02 14:53:52 EDT 2003 | scottefiske
We are currently looking at a CS-400D component > locator with automatic cut & clinch from contax > ltd .Anyone who has had good or bad experiences > with this type of equipment and are prepared to > share,it would be much appreciated. Are you b
Electronics Forum | Wed Jun 11 10:24:23 EDT 2003 | kris
Hi, The percentage of lead (0.1% or otherwise) is still being debated in the EU where the legislation is in place. The industry is pushing for a 0.2% limit,(if lead-free has to be) as it is considered a limit where solder can be recycled economical
Electronics Forum | Thu Jun 12 08:02:57 EDT 2003 | Claude_Couture
Hi all! I'm stuck with this Panasonic paste printer (used). The menus come up in japanese. I know the secret menu screen is the one I have to get into to change the language to english. Does anybody know how to get to the secret screen on Panasert SP
Electronics Forum | Mon Jun 23 11:02:33 EDT 2003 | Kris
Hi, No Major issue using lead-free plated components in tin-lead as long as Sn/Bi is not the finish. I think some customer might be worried about low melting phase. More voiding may be seen in case of ceramic capacitors used with tin-lead. It is
Electronics Forum | Fri Jun 27 15:37:02 EDT 2003 | caldon
Charlie- You answered your own question...1206, 0201, 0603, 0805, 0402 are all the package dimensions. In addition Here is a generic link from practical components that list most package sizes, feeder size, tape type... http://www.practicalcomponen