Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Thu Aug 28 15:29:50 EDT 2014 | mcapizzi
Yes, your picture is correct. Regarding the dichroic mirrored prism assembly…in this application, a dichroic material is one which causes visible light to be split up into distinct beams of different wavelengths. The original meaning of dichroic, fro
Electronics Forum | Thu Sep 04 05:18:45 EDT 2014 | sasa29
PCB Manufacturing demands preparation of design well in advance. The finalized designs are fed into the systems and the production is carried away. If the boards are of small sizes, multiple boards are made on a single large board and separated into
Electronics Forum | Thu Sep 04 16:36:29 EDT 2014 | chemers
Thanks for the response, Rob. I tried the MOT cards and the problem did not move. I swapped the MOTY with the MOTX, but the MOTX had a small board attached to it that I moved to the MOTY that I tried. Do you know if there is a way to test that small
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
Electronics Forum | Sun Sep 07 13:33:50 EDT 2014 | horchak
Edri PCBA design and pad geometry is one of the critical factors for BGAs. Typically the pad size for collapsible balls is 80% of the ball diameter. Pad size consistency is critical. In your situation what will happen the larger pads will wick the s
Electronics Forum | Tue Sep 16 13:43:48 EDT 2014 | gascon5383
We have new stencils produced every 15000 prints. Another technician takes care of that and he uses gerber files to have them produced. Also, we have over 300 different products that are produced, all board sizes are standardized 287mm long x either
Electronics Forum | Mon Sep 15 14:14:47 EDT 2014 | riot983
Hi guys, New to the forum. I always read and look around at used equipment but have never posted. Anyway, I operate a Mydata My9 at a small shop and have recently ran into a problem and wanted to get some good advice. An employee of mine cleaned the
Electronics Forum | Mon Sep 15 23:59:09 EDT 2014 | marcelorotofrance
Hi evreybody I wish to know if somebody can describe how is made a "Calibration Slug" for centering the upward camera of a QUAD IVC machine. The instruction manual mentions a slug that is attached with vacuum to the "Vision Nozzle" and there is some