Electronics Forum | Wed Aug 21 09:09:50 EDT 2013 | wcheew
I am having solder barrel fill issues on THM component, we follow, we follow IPC 610 E requirement. The barrel fill issues happen on signal & ground pin at connector & E-cap. I found out that most of the insufficient solder happen on the connector ag
Electronics Forum | Thu Aug 22 13:31:23 EDT 2013 | bvdb
Re-doing this thread as original seems to have been shortened. Our beloved 24 year old Fuji IP-1 fine placement machine won't start. Has been working fine for the past 6 years but now when the Power button is pressed the power comes on but the FAIL
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Mon Jun 16 10:52:02 EDT 2014 | robstarrs
bobpan quick background. I am very new to the Quad machines, I used to "run" one, but I never learned the inner workings of a machine. I just purchased 2 used quad 4cs, I had a training session over the weekend with a very knowledgeable guy and l
Electronics Forum | Thu Aug 29 11:56:21 EDT 2013 | kdc45
Sent program to a CP43 and the part data was not recognized. Machine message to power down and back up, so we did so. On power up, screen appeared with the following: OS Error Err Code 0001 Err task 0028 Err para FFFF Ex stat 0151 Err adrs CC400000
Electronics Forum | Thu Sep 12 20:42:16 EDT 2013 | marcelorotofrance
Jorge: Nosotros tenemos una óptica 0KM embalada perteneciente a Martín. Se la dio a Bruno cuando palmó la nuestra, sin embargo el equipo nuestro tiene el otro modelo. Si querés pasala a buscar y la probás. Estoy seguro que es la solución al problema,
Electronics Forum | Mon Sep 09 12:00:01 EDT 2013 | proteus
I have a 208 pin QFP that due to manufacture obsolescence I have to get them form the broker market. I've had several issues with the parts including; bent leads, leads that don't take solder very well, co-planarity problems, and DOA fallout after a
Electronics Forum | Mon Sep 09 16:29:56 EDT 2013 | gregp
Hi Everyone, I'm looking for some feedback about through hole assembly requirements today vs. yesteryear. As I see it, there are two main categories...legacy through hole and new through hole with mixed technology. The legacy stuff is older designs
Electronics Forum | Wed Sep 11 15:12:02 EDT 2013 | rway
"Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts?" That depends. It will still save time if your lot sizes are small, as opposed to hand placement. I would not recommend buying an
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
