Electronics Forum | Thu Jan 30 06:36:37 EST 2014 | sigmaprint
We still have two of these machines as well. Let > me know if you still need the software, I think > we have a copy around here I can copy. > > If you > have an FTP site I could probably upload a CD > image for you. > We still have two of the
Electronics Forum | Fri Nov 22 16:55:30 EST 2013 | hegemon
Head and Pillow defects beneath a BGA are difficult to find, no matter what the equipment is on hand. Since you do not appear to have access to tools that would help you, or $$ to purchase said tools, I might recommend that you use an outside source
Electronics Forum | Mon Nov 25 18:43:29 EST 2013 | hegemon
Without the proper tools in house you will not be able to determine anything but the most obvious problems. At minimum, some side looking microscope that would allow visual inspection of a row or two, and to be able to rule out bridging. Using that
Electronics Forum | Sat Nov 23 12:39:18 EST 2013 | joeherz
We installed a Soltec Delta 3 a few months ago and have been trying to run with a VOC free no clean. We're using SN100C in the pot. We are spraying the material and have top/bottom preheat. Evaporation of the water in the flux is a bit of a stru
Electronics Forum | Mon Nov 25 03:14:57 EST 2013 | mg2013
Hello @ the specialists, we have a Nordson Asymtek SL940 to coat our pcb's. We can use the valves SC100 and SC400 for conformal coating applications. We use the Humiseal 1A33 as the conformal coating. Now we would like to use the standard 1A33 in th
Electronics Forum | Wed Nov 27 09:43:17 EST 2013 | mchawg
We recently rebuilt the generator and power supply on our '97 vintage Optiflux Ultrasonic fluxer. That cleared up all its issues except. Ultrasonics are reported by all indicators to be running in both Setup and Run mode, however, the nice rooster-t
Electronics Forum | Sat Dec 14 02:29:52 EST 2013 | padawanlinuxero
Hello I hope this helps For a component with axial leaded - vertical The clearance of the component body or weld bead above the land is 1.00mm (0.039in) Component body must be perpendicular to the board The overall height does not exceed maxim
Electronics Forum | Wed Jan 15 22:28:51 EST 2014 | padawanlinuxero
dave I am so sorry for Lou he had to be a good man for you to remember him so fondly, but Winamp is not death! here : http://gizmodo.com/an-ode-to-winamp-1487246843/1500988875/@ericlimer and I quote : "Last month, Winamp sauntered up to the brink
Electronics Forum | Thu Dec 26 12:12:55 EST 2013 | igorfo
Dear Friends, I need your help to understand requirements and measurement methods for bow and twist of assembled PCB (PCBA have and SMT and TH components). I already check all posts on the site but didn't found any related to my question answers.
Electronics Forum | Thu Jan 02 04:56:38 EST 2014 | bobpan
Here is a couple of things to look at: 1. Make sure the boards are plugged into the correct position. Also just leave out the transport card to see if its hanging up the machine. The transport board should be the board all the way to the right. 2. M
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835