Electronics Forum | Mon Jun 13 21:08:12 EDT 2005 | davef
Paramjeet Singh Gill So, you underfil before cleaning. Interesting. * What is it about your underfill that prevents the OA flux from attacking the FC solder balls? * Who is the underfill fabricator and product? Getting back to your solder balling
Electronics Forum | Wed Aug 16 03:48:24 EDT 2006 | umar
Hi All SMT Net Team Member, I always have problem at MY SMT process and production side, Every time product running at my production side always found a lot solder Ball issue near the pad of SMT chip component. We had quite hard to do the trouble s
Electronics Forum | Tue Apr 28 21:48:50 EDT 2009 | davef
Confirm the source of the issue. Run a coalescence test on both lots of paste. A simple coalescence test can quickly determine the condition of solder paste after prolonged use. Simply print a small disk [around 4-5mm diameter and 0.2mm thick - a bu
Electronics Forum | Thu Mar 19 15:01:00 EDT 2020 | emeto
Overprinting until the solder paste start detaching from the joint and start forming solder balls. Based on finish, chemistry and type solder mask this number will be different.I also wouldn't call it "better solderability".
Electronics Forum | Thu Feb 24 06:09:26 EST 2000 | Robert Hutton-Squire
Hi, - any suggestions welcome... I have a 484 pin ALTERA fineline BGA - ball pitch 1mm (40) - ball size 0.48mm (18.9) What would you recommend for... 1. Surface pad size for the balls of this BGA device? 2. Stencil thickness/type and hole a
Electronics Forum | Thu Feb 24 06:09:26 EST 2000 | Robert Hutton-Squire
Hi, - any suggestions welcome... I have a 484 pin ALTERA fineline BGA - ball pitch 1mm (40) - ball size 0.48mm (18.9) What would you recommend for... 1. Surface pad size for the balls of this BGA device? 2. Stencil thickness/type and hole a
Electronics Forum | Thu Jul 15 12:07:36 EDT 1999 | Mark
| What are some suggested standards/speced requirements and procedures for removal/addition of missing balls on laminate and ceramic based bga packages and quality requirements for same. | There are a number of methods available. 4 of them are discu
Electronics Forum | Wed Mar 13 10:20:51 EST 2002 | IAN T
WE HAVE A PROBLEM WITH SOLDER BALLING POST REFLOW WE ARE RELIABLY DISPENCING HERAEUS PASTE WITH A XY FLEX BUT WE'RE GETTING LARGE BALLS ON THE MELFS AND SMALL BALLS ON MOST CHIP PARTS WHAT SHOULD I BE LOOKING FOR? AND IS PAD DESIGN AN ISSUE (ROUND DO
Electronics Forum | Sat Apr 08 09:32:51 EDT 2000 | Matt
Make sure your screen aperture size is about 80%, and you should not have a problem. Some pastes require a hump profile, to get rid of balls.
Electronics Forum | Wed Feb 17 16:39:05 EST 1999 | 3D
What are some suggested standards/speced requirements and procedures for removal/addition of missing balls on laminate and ceramic based bga packages and quality requirements for same.