Electronics Forum | Mon Jul 11 07:40:11 EDT 2016 | spoiltforchoice
I don't know your machine but you are looking at the most likely areas. Some machines define a placement pressure, other may define an overtravel to make sure the device is firmly placed on the board. There are usually also timings for when the vacuu
Electronics Forum | Mon Jul 11 11:05:53 EDT 2016 | bradholland
thanks for the replies so far. So far I have been relying on the board clamp on the machine that closes when the pwb is loaded. I have also been doing these tests with double sided tape on the pwb so i can clean them off easier afterwards. I have
Electronics Forum | Tue Jul 19 10:28:21 EDT 2016 | mrk
What kind of oscillator are you placing (Manufacturer part #)? I do not believe that oscillators fall under the "chip component" category. Even if they did, most all SMT oscillators that I have come into contact with have 1 sided terminations on the
Electronics Forum | Fri Jul 29 13:30:43 EDT 2016 | gregp
Versatec specializes in the remanufacture of Contact Systems machines, most notably the CS-400E component locator with programmable cut and clinch. these machines are field proven over the past two decades and provide many benefits when utilized: 1.
Electronics Forum | Mon Jul 25 09:45:39 EDT 2016 | spoiltforchoice
How do you answer that question? You probably won't find anyone who has worked with both which leaves them comparing datasheets just like you presumably already have. http://www.e-by-siplace.com/28657/E-Performance/Overview/e_series_stage.aspx?slide=
Electronics Forum | Mon Jul 25 16:35:37 EDT 2016 | paperbackryder
I will second the comments of SpoiledByChoice. Not enough info about your intended use to make an informed recommendation...so considering that, IMO/IME, both companies make excellent machines and have great offline software. The AIM100 & E-Series a
Electronics Forum | Fri Jul 22 09:42:24 EDT 2016 | ttheis
Acetone has hazards other than flammability and odor including potential effects on the nervous system, skin, kidneys, GI tract, as well as blood and bone marrow according to the CDC. Perhaps you misunderstood what I was saying regarding alcohol; I
Electronics Forum | Mon Jul 25 09:11:25 EDT 2016 | spoiltforchoice
There 2 main rival standards for orientation in tape and because you can't really trust manufacturers to stick to one or the other or something else entirely it is always wise to check the datasheet. Typically an SOIC will have pin 1 the same end as
Electronics Forum | Mon Jul 25 04:49:28 EDT 2016 | chris10
Hi, To enlarge the 3.6 V of PWM wave of MCU to 6 V which control on and off of transistors. But op-amp part never amplifies out . Simulation diagram is shown in the figure. Op-amp is LM368h and 8 v single power supply.The datasheet of LM368h is http:
Electronics Forum | Thu Aug 04 15:07:30 EDT 2016 | sumote
I have seen a similar error on a Quad 4C machine. When setting up the parameters on a tray part there are several points of data you have to input. You have to teach where the center of the 1st part (and you have to know which corner your machine con