Electronics Forum | Thu Jan 13 16:15:05 EST 2005 | fmonette
Hi Steve, My company offers this kind of system in two different versions ; a low-cost semi-automatic configuration using barcode labels and a closed-loop configuration using RFID tags to retrofit existing feeders into smart feeders. Please contac
Electronics Forum | Mon Feb 28 16:04:30 EST 2005 | Alex
I use to have that kind of problems with other type of machines and here are the causes: 1- Spray fluxer head partially obstructed (check flow rate) 2- Defective pre-heater probe (manually check temps) 3- PROFILE (last preheat to 280) 4- we sometimes
Electronics Forum | Mon Mar 21 08:46:05 EST 2005 | GS
Hello Gents, Many thanks Davef for your always helpful informations. I have a question, pls, related to : which kind of Test Method are they going to be used to perform analysis (Rohs Compliance verification tests) on EEE in order to find out oncen
Electronics Forum | Thu Mar 17 11:07:08 EST 2005 | Dougs
I'd agree with Justin, we do double sided reflow on most of our boards with fine pitch QFP's both sides, you do have a problem somewhere else, what size is you board? Is it warping slightly? What kind of oven are you using? Is it convection? fans
Electronics Forum | Mon May 09 15:26:45 EDT 2005 | ricardof
I'm really getting a lot of fun, at leat Rob has some good points matching technology and humor. These kind of questions should be out of the forum, what I suggest is first to do some research previous to make any GENERAL questions about what SMT pla
Electronics Forum | Tue May 10 00:09:46 EDT 2005 | Dr . Klein
Hello (pwh) I would like to know more about your process. What is the rezone you open the bags? Do you put any stamp on the opened trays before you enter them to the mcdry? What kind of inspection do you make before you enter the trays to the mcdry?
Electronics Forum | Thu May 26 11:38:08 EDT 2005 | nicholas2005
Yes I understand its precision, And I have been talking with handful's of people to discuss precision, design, pricing, and manufacture. The question I had was the patents, but as it was said "davis". As for precision, I would most likely be going w
Electronics Forum | Thu May 26 16:11:24 EDT 2005 | nicholas2005
What if just the base of say a cp-6 was produced, including fin. but inner workings,reel,etc. were already oem products. say i purchased all inner workings and so forth from another company, but the base design(provide all fits together properly) wou
Electronics Forum | Mon May 30 03:13:49 EDT 2005 | Joris Groot Koerkamp
Hi rob, We use the component for a long time and never had a problem with the reflow process. Since the component is Leadfree we see the problems. We have the same problem with defferent pcb's. The tin not always flows to the same direction. I check
Electronics Forum | Fri May 27 16:27:14 EDT 2005 | cmiller
Could be a lot of things but try this, on the SPM that we have the lead screw that moves the blades up and down runs through a piece of threaded plastic. When it strips out, it starts to cause all kinds of wierd problems. The replacement part we got