Electronics Forum | Tue Jul 16 02:18:42 EDT 2019 | sy332366
Specifications : S-8800 Number Of Heating Zones :Up8/Bottom8 Dimension (L*W*H)mm: 5310x1353x1490 Dimension (L*W*H)mm: 5310x1353x1490 Number Of Heating Zones : Up8/Bottom8 Length Of Heating Zones : 3121mm Control System : PLC+Computer Transmission Age
Electronics Forum | Sat Aug 03 01:40:24 EDT 2019 | sarason
I own a metcal for the high precision work 1500$ in 1992 tips $60 in 1992 and have only used one tip in all that time, have horses holves for large pin devices, precision points for 0402 and a largest tip for service work. Also have Hakkos for bulk
Electronics Forum | Tue Jan 05 14:45:27 EST 2021 | aharper
We had to register our machine with ASYS Group to get the digital manual and to receive tech support. Unfortunately, I am not at liberty to distribute the manual outside our company. As far as the rear computer, I can't imagine your machine working w
Electronics Forum | Tue Aug 27 16:39:39 EDT 2019 | spoiltforchoice
There is no formula out there that chooses a model for low volume high mix. Every oven can manage the throughput, which leaves us with cost, servicing, flexibility and reliability. Ersa Pros: Longer heated length than the ovens I am comparing it t
Electronics Forum | Fri Aug 02 12:57:38 EDT 2019 | aaronhodge
Hello All, I am a few months in with a new employer, spending much of my time with AS9102B First Article Inspections. This company is a Micro-Chip and PCA OEM but also designs, develops and manufactures products for a handful of customers, as well.
Electronics Forum | Tue Aug 27 02:55:43 EDT 2019 | oxygensmd
I am looking for a simple software which I can use in my production. I have the following task which I would like to solve with this software: - Components storage: counting the components in my production area. I would like to store their following
Electronics Forum | Wed Nov 27 08:54:03 EST 2019 | ttheis
Hi Tushar, Thanks for the reply. I do believe I put it into debug mode but I will be sure to check next time I try logicomm. I am not using any RAMTF or PTF. At the moment I have upgraded the machine from EPC-5 to EPC-5-66 which I found cheap. The
Electronics Forum | Fri Sep 27 13:34:34 EDT 2019 | tey422
We are to install a very small BGA socket, the datasheet noted to be torque the M1.6 size Phillips screw to the spec for installation. I couldn't find the correct size bit that would fit our torque screwdriver. Per the screw size, shouldn't it be PH0
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Tue Oct 08 15:02:10 EDT 2019 | SMTA-Joe
Hello SMTA, I am looking into the possibility of automating, or semi-automating the application of thermal gel (THERMA-A-GAP GEL8010) onto the bottom of some power supplies installed in PCBs. As of now I will need to apply approx. 5 mils of this gel
