Electronics Forum | Mon Sep 21 10:23:46 EDT 2015 | koprivecj
Please look at folowing link. http://shrani.si/f/3l/xt/3ZHqDv6X/padconnectproblem.png I think that there would be no problem with full pouring the via. But i don't know if it is good to fully pour the PAD in inner layers? Any suggestions?
Electronics Forum | Wed Sep 23 03:03:06 EDT 2015 | stivais
We are looking for an expert at Teradyne XSTATION MX, machine type 8022 AXI programming (2D, 3D). Is here anybody who has an experience with this machine?
Electronics Forum | Wed Sep 23 13:20:02 EDT 2015 | emeto
Depends on the MSL(Moisture sensitivity level) and how far you will use them in production. Here you should be able to get all the answers: http://www.jedec.org/sites/default/files/docs/jstd033b01.pdf
Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Tue Sep 29 20:44:36 EDT 2015 | dekhead
I can probably help you with manual and prints. Please contact me directly. www.dekhead.com
Electronics Forum | Thu Sep 24 07:14:39 EDT 2015 | mrnollid
What is the tolerance for inspecting a 28 pin IC in a socket? If it's not sitting flat to the socket, what height is acceptable?
Electronics Forum | Thu Sep 24 07:25:34 EDT 2015 | anilwagh
I have Cyberoptics SPI SE300 Ultra machine purchased from auction. I need service/Electrical/Program manuals.
Electronics Forum | Tue Sep 29 14:54:03 EDT 2015 | bmalhi
Voltage retrofit require some wiring changes along with circuit breakers replacement. Please contact serviceNJ@hellerindustries.com to get the retrofit quot.
Electronics Forum | Tue Sep 29 18:20:56 EDT 2015 | ercdave1
Rob,. thank you very much for the reply. I will follow your recommendations and verify that the stop bar is not damaged or misaligned. I will also thank you for the info for the service . I will keep you posted. Thank you again. David
Electronics Forum | Tue Sep 29 10:53:42 EDT 2015 | marlyn
Hey there fellow people with SMT issues... What's the proper procedure for soldering through-hole headers on the back-side of the PCB (pins poking out on same side as SMT parts)? ( Yes - I did the SMT side first and am now faced with LOTS of pin-poin