Electronics Forum | Wed Jul 03 15:14:18 EDT 2024 | SMTA-74487602
I'm hoping to hear what others are doing regarding "recycling" paste. By recycling paste, I'm referring to an operator taking the paste left over on a stencil after a work order is done and putting it either back into the jar it came from originall
Electronics Forum | Tue Jul 16 07:55:46 EDT 2024 | ginny
> We're currently running a pair of XPM 820 > Vitronics reflow ovens with a year 2000 vintage. > I'm looking into either replacing both with used > or one at a time new (and using the 2nd for spare > parts). I priced a new delivere
Electronics Forum | Wed Jul 17 16:00:01 EDT 2024 | spoiltforchoice
Heller and BTU both sell well respected ovens for considerably less $$ than a Vitronics. If you really like ITWAE brands, when I was last looking Electrovert was somewhat more affordable. Your region may also have other reliable Chinese brands, I thi
Electronics Forum | Tue Jul 23 12:56:03 EDT 2024 | proceng1
One trick that I use when I need additional paste for a larger part like a connector with thick leads is KAPTON. I'll put a thin strip of Kapton on the board side of the stencil along the apertures where I need more paste. Kapton is about 2.5mils th
Electronics Forum | Tue Jul 30 22:11:09 EDT 2024 | zsoden
We've been running a trusty MPM UP2000 printer for a few years now but the 30 year old technology is starting to struggle a bit. It didn't come with snuggers and the vacuum hold down just doesn't cut it for some of the finer pitch stuff we're now doi
Electronics Forum | Tue Aug 06 13:29:39 EDT 2024 | poly
I'm having a lot of trouble placing a long thin connector (DF40C-100DS from Hirose) all my other parts including 0.3mm pitch parts are placed very well, but this part is much longer than anything else and is often placed with rotation or position err
Electronics Forum | Thu Aug 08 11:39:53 EDT 2024 | stephendo
I used an early Mirtec about 20 years ago. I think none of us had previous experience with AOI at the time. We of course had a learning curve abut Mirtec was great with support. But we had trouble with false fails and part of the problem was bad imag
Electronics Forum | Thu Aug 08 12:01:46 EDT 2024 | proceng1
We relocated an operator from AOI. There were a few issues, but one that really caught the attention of Engineering was that an IC with 4 legs on one side and 3 legs on the other was placed 180° out. The machine flagged it. The operator looked at t
Electronics Forum | Tue Aug 13 23:22:50 EDT 2024 | simonattwood
3.4 says the solder paste shall meet requirements of 3.3 3.3 says the flux shall be L0 or L1 or if it is not you must have data demonstrating compatibility as per Appendix C. So if you wanted to use ORH0 solder paste, and be J-STD-001 compliant, yo
Electronics Forum | Tue Aug 20 01:04:15 EDT 2024 | ttheis
Our dek APi X started having alignment problems suddenly and we aren't sure why. The board is close, but mainly shifted toward the rear of the machine so we are not able to print with it. I performed reference alignment which works properly. I then