Electronics Forum | Fri Apr 29 11:23:27 EDT 2022 | dontfeedphils
I typically use kapton tape when I need to mask off some apertures.
Electronics Forum | Thu Aug 26 04:35:54 EDT 1999 | Wolfgang Busko
| | | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products.
Electronics Forum | Wed Aug 25 17:09:53 EDT 1999 | Earl Moon
| | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products. Co
Electronics Forum | Mon Feb 18 09:39:21 EST 2008 | swag
We do like Chunks says only a little bit different. Our stencil supplier e-mails us a "confirmation PDF" before processing any order. If it's a simple board, I just make sure all the apertures are there by comparing to board. If it's got a ton of
Electronics Forum | Tue Apr 20 20:10:16 EDT 2004 | Indy
Hi Everyone, I am trying to stencil print chipbonder. The problem I am having is with the cleaning of stencil. The apertures are gettting blocked and cleaning with alcohol is not helping. Could anyone suggest a better way of cleaning the stencil. I
Electronics Forum | Mon Feb 18 11:31:02 EST 2008 | davef
Print paste through the new stencil with a piece of mylar [or other clear plastic sheet about the thickness of paper] between the board and the stencil. Dispose of the mylar according to local practice after confirming proper aperturation of the sten
Electronics Forum | Fri May 17 14:12:17 EDT 2002 | dason_c
Not now, Valor may under develop the module for its Trilogy 5000 with the stencil aperture based on the rules which you set. Also, check with IRI stencil (Alpha), they have a s/w and based on using ODB++ file and not Gerber. Rgds.
Electronics Forum | Wed Feb 22 08:02:56 EST 2006 | dj44
I was looking for an stencil design for a 0.5mm pitch uBGA. Pad size is 0.38mm in diameter. We have been using 5mil stencil with type 3 no clean paste. What size aperture should we be using? Any suggestions?
Electronics Forum | Wed Jun 19 15:22:34 EDT 2002 | pdt203
Does anyone know the name of a smalll handheld device that cleans stencils? One looks like a palm sander and it vibrates the paste out of apertures. Thanks, Johnny Smith
Electronics Forum | Tue Jul 19 11:21:50 EDT 2005 | russ
You may want to try reducing the large center aperture on your stencil to 50-70% of the area of the pad. This is what we do with QFNs and it may be applicable in this case also.
