Electronics Forum | Fri Mar 24 15:08:20 EDT 2023 | erikfriesen
The nameplate specs for a 2004 Heller 1088EXL show 240V 60A, and specify Largest Heater Load of 25A. As each of the 8 heater elements is 6000W or 9.5R, how does this really work? Obviously all 8 elements on would pull 200A, so does the machine only
Electronics Forum | Sun Nov 12 17:35:40 EST 2000 | Darby
George, You need to calibrate your chucking assemblies! . What you are seeing is poor alignment due to egocentricity in you jawing assemblies. Also make sure that your jaws/nozzles are in good condition and that your assemblies are correctly orientat
Electronics Forum | Sat Sep 30 11:59:30 EDT 2000 | jarnopy
Hi! What kind is perfect smt line? It's difficult question. First you must know what kind your production is. Do you have a serial production or do you have a lot of proto series? If you have only few different pcb then you must get placemant machine
Electronics Forum | Wed Nov 18 10:45:22 EST 1998 | David Reese
Our company has been building high rel military products for over 15 years. Over that time we have reduced our bare board suppliers to two companies that specilize in 55110 QPL product. I am now faced with a requirement for 6000 4 layer boards to
Electronics Forum | Fri Sep 18 21:37:50 EDT 1998 | Jeff Sanchez
| Good Morning, | I am looking for an alternatve to the traditional press in low profile sockets, aka Augat Holetites. I am looking into Mill-Max parts. any suggestions? They are used on the backplanes we build. | Thanks, | Wendy Mill-Max
Electronics Forum | Fri Aug 17 12:07:40 EDT 2001 | davef
We always get pissed-off a preform suppliers when they tell us that we need to do NRE to develop a preform. Is that BS er watt? Ya got this vanilla connector that everyone on the planet uses and we have to pay NRE. It's just a scam. Try Teka Inte
Electronics Forum | Wed Jul 09 16:09:47 EDT 2003 | russ
I would always recommend that an oven be used. I am not familiar with the ERSA rework system so I cannot comment. The key is to heat evenly with the correct ramp rate. If your rework station does this well then use it. if not I would put through t
Electronics Forum | Thu Mar 25 11:09:29 EST 2004 | paul_bmc
I ran into the same problem. What I had is a customer that required us to use a No Clean because of the Low flux activity then they want it cleaned. Well to clean the No clean your going to use such a high percentage of cleaner in your sapinifer th
Electronics Forum | Tue May 04 10:59:23 EDT 2004 | Evtimov
Hi, It depends of your boards(are they for SMD or not) and how many boards you assemble. The process at all is like that: 1.Stencil printer - to adjust the paste 2. Pick and place machine(for your quantity) 3.Reflow oven Theese are the machines you
Electronics Forum | Fri Dec 09 05:03:35 EST 2005 | rlackey
Hi, I'd be inclined to go with the through hole capacitor, as to surface mount it you would probably need to go for an elco (ceramics & films don't do that value in that voltage, & you'd be hard pressed to get a tant in that voltage). SMD Elcos a
winsouce.jpg)
