Electronics Forum | Tue Oct 12 17:40:01 EDT 1999 | Brian W.
| | | A question for you all! | | | | | | Back in the good old days, we didn't always know how clean was clean. Much has changed. Much hasn't. | | | | | | My question concerns cleaning under, through, and around tight spaces. Way back when, we coul
Electronics Forum | Fri Jan 14 16:55:31 EST 2011 | tombstonesmt
On our Pilarhouse Jade we use nitrogen to cool the belt that drives our solder pump as well as keep the amount of oxygen to a minimum in our solder pot to reduce dross.
Electronics Forum | Sun Nov 07 21:00:15 EST 2010 | mainenetservices
sounds like its probably a timming belt. stock drive products is the place i go for robotics mechanical stuff, They likely have a sutable belt if you can get a good mesurement on everything(mesure the pully teeth, the belt may be streched). https://
Electronics Forum | Tue Sep 14 17:49:36 EDT 2010 | g2garyg2
The problem with the Sunsda units is that they use a special circuit board, not PLC and Chinese software for programming, so getting into the program to find out what is going on is a problem. Have you replaced the SMEMA cable? I have seen bad ones.
Electronics Forum | Thu Jul 22 07:30:21 EDT 2010 | nitronica1
does anyone know where I can get replacement conveyor/drive belts for a Fuji/astro pcb 0.5m conveyor? pref from the UK or europe the length of the belts are approx 630mm and 6mm wide, flat with bumps on bottom side
Electronics Forum | Thu Apr 19 01:50:49 EDT 2018 | leeg
Whats the best way to joint a broken conveyor drive belt? Ive tried a rubber glue which lasts for a short time and tried touching both sides to an iron tip and then holding together, again with poor results.
Electronics Forum | Tue Mar 17 10:15:27 EDT 2015 | dyoungquist
What model of magazine are they? Are they the older black "TM" magazines or the newer "M" or "LM" models? On "TM" magazines, if the upper tape collecting reels are not turning for every slot in the magazine, the belt that drives the tape collection
Electronics Forum | Wed Apr 29 15:08:24 EDT 2020 | davef
Consider focusing on: * Regional suppliers that are within driving distance * Tier 4 suppliers LT $100M revenues STI used to advertise on SMTnet contact Mark McMeen mmcmeen at stielectronicsinc.com. Other quality suppliers in this tier are: Libra
Electronics Forum | Thu Jul 13 18:33:26 EDT 2006 | SWAG
Thanks Mika and Pitbull - worn z-drive belt is the answer. Looks good from the outside (not frayed on the edges or anything). Removed it and it's missing some teeth. New one = runs fine.
Electronics Forum | Fri Nov 05 22:45:04 EDT 2010 | wingding
Does anyone know where to but parts for Hover Davis feeders. I need a 18 ½ x 1/8 inch drive belt for a Fuji feeder.
