Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Thu Apr 29 14:16:58 EDT 1999 | Kevin Simpson
We will be moving our entire plant in a couple of months . We are in the process of installing communication cable etc, to allow for a easy drop machine in line type move. ( is this possible) My question is what type of communication cable would be
Electronics Forum | Sat Mar 24 00:08:55 EDT 2007 | mika
Fully SMPI (there are 2 kinds of SMPI and Universal used them both in the past). Converter cables between SMPI > Fully SMPI Converter cables between FUJI > Panasonic Converter cables between FUJI > SMEMA Converters between almost any machine interfac
Electronics Forum | Mon Mar 03 13:56:15 EST 2008 | daxman
Resolved! Jeeze...just after I posted this question I got the machine working. Someone had removed the cable for the wide camera and connected it into one of the ports that is unused. I noticed this when looking at the schematic. The cables had
Electronics Forum | Tue Dec 02 02:11:39 EST 2008 | raranchado
We're using a PFC (Product Flow Controller) box by Cogiscan between a conveyor and Agilent SJ-5000 (AOI) and the problem we're having is that when the downline smema cable is connected to the PFC box, the AOI conveyor belt keeps on turning even with
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
Electronics Forum | Mon Apr 11 08:27:10 EDT 2011 | leemeyer
I have had similar problems before where the machine will intermittently stop with a limit error. Reset the machine and away it goes. Replacing the ribbon cable that runs from the head (37 pin D-sub)has solved this problem. This cable gets flexed a l
Electronics Forum | Mon Jan 28 16:05:27 EST 2013 | jdengler
It's been a long time since I did this. I think if you get a cable (maybe from some of the used equipment dealers that advertise here) you will still need to change the contacts of the relay the Fuji uses. I think they use a normally closed set of
Electronics Forum | Thu Jan 13 15:08:22 EST 2022 | emeto
Hello Jeff, error is telling you exactly what it is - communication problem. CAN interface is interrupted somewhere. Motors are constantly sharing position and commands with computer over CAN interface. To get this message means somewhere this circui
Electronics Forum | Mon Sep 27 12:01:19 EDT 2004 | lgroves
John, My best guess is the "Y" encoder - or the encoder cable. The encoder is a part of the motor assy on the QSA-