Electronics Forum | Fri Jan 12 15:35:05 EST 2024 | madisreivik
On my CP642 I got narrow camera for 0201 parts. My question: some thick (2mm+) 0805 components look blurry. Is there a part height limit for the narrow camera ? I noticed that some parts predefined from previous owner were made to wide camera, alth
Electronics Forum | Thu Mar 23 04:44:46 EDT 2023 | gwideman
We are looking to obtain (probably make) the calibration tools used in the camera calibration procedures. To that end, any photos and dimensions would be highly appreciated! The set consists of one or two plates and a hat that fits on the up camer
Electronics Forum | Wed Jul 04 09:54:07 EDT 2007 | timstevenson
I have posted on the advert site the my need for this camera. All the responses are from off shore and I am hesitant to deal with someone where their is no chance for recourse . Does anyone know a North American source for this camera ? Juki sells it
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Wed Jan 18 11:26:22 EST 2017 | dilogic
Is there something special to care about while reflowing CMOS camera chips? They are pretty reflective on the surface, so I guess IR-type oven is not the best choice...
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Thu Mar 23 07:17:30 EDT 2023 | bukas
I have one plate and nozzle if you want dimensions. And fly camera tool.
Electronics Forum | Sun Sep 25 20:20:22 EDT 2011 | johnyq
We recently aquired an old MPM-AP25 stencil printer that printed paste with a large error (about .060 inches). I concluded camera alignment to be the cause but was surprised by the magnitude. I found the camera beam splitter prism misaligned and loos
Electronics Forum | Tue Oct 09 11:17:24 EDT 2018 | dfl
Ok, I will try and post the result. thanks for the help!
Electronics Forum | Fri Mar 24 08:01:04 EDT 2023 | bukas
ill send you PM
.gif)
