Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a
Electronics Forum | Thu Jul 31 14:52:38 EDT 2014 | rgduval
As I understand it, customized equipment for breaking the headers out can get fairly expensive. I've used two methods to do these, other than using cutters. First, we bought a bandsaw to use for cutting. The only disadvantage to using the bandsaw
Electronics Forum | Thu Aug 22 23:09:34 EDT 2019 | sssamw
Yes, you need work with supplier to see if can run pin in paste for these connectors, even do some experiments. A step-up stencil would be good for these connectors, also connectors pin size and length match with PCB hole design.
Electronics Forum | Tue Aug 10 05:32:42 EDT 2004 | praveen_madaan@jabil.com
Hi, Has any body experienced the problem of poor cotacts on HDMI connectors. The connectors pins are gold plated and we see some kind of white residue on the gold pins.How to check if this is a flux residue?We are using No Clean flux in wave solderin
Electronics Forum | Fri Jul 10 08:31:03 EDT 1998 | Greg Curler
We are considering the use of compliant pin connectors on surface mount assys instead of pasting thru-hole connectors (boards can't be wavesoldered). We are looking at VME mother & daughter connectors, and compiant pin sockets that would replace PGA
Electronics Forum | Wed May 16 14:09:22 EDT 2001 | davef
First thing I'd use is IPC-A-610C, �4.8.2 Connector Pins - Press-Fit Pins. Does it work in your case?
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Tue Nov 07 09:26:37 EST 2000 | Peter Barton
Adam, The most common cause for this problem is a variation in the plating thickness of the through holes, particularly if they are Sn/Pb solder levelled PCB's. Most pressfit connectors require a fairly tight control on the diameter of the holes to
Electronics Forum | Thu Apr 18 14:00:35 EDT 2002 | Romain
Is anyone has experience on problems with press-fit on Ni/Au board finish. Connectors pins are SnPb finished. I am particulary interested by experiences or documentation in very agressive environmental conditions (avionics or space buisness) Thanks r
Electronics Forum | Wed Apr 06 11:54:24 EDT 2005 | Indy
did you try using double header connector pin of a different lot? Indy
