Electronics Forum | Tue Sep 07 12:05:39 EDT 1999 | Brad Kendall
| I am looking for some PM software to use throughout my Electronics factory. Currently, we have a manual system consisting of check-off sheets, log-books, etc. Ideally I would like a system that would throw-up a flag (perhaps by e-mail) when PM is
Electronics Forum | Sun Mar 21 22:03:35 EST 1999 | Nick
It looks like your holders now require some maintenance. You will need to throughly clean all the holders of all dirt debris and then relube the holder lightly with T&D or grease. You will only need to lube the shaft of the nozzle change enagager an
Electronics Forum | Thu Mar 11 08:25:58 EST 1999 | Dave F
Thanks Steve. Once I spent almost a week with a torch, chisel, hammer, and other "tools of ingnorance" removing accumulated solder that had finally ceased the conveyor of a wave solder machine. From then on, I pledged myself that for myself ( and e
Electronics Forum | Tue Jan 26 19:43:02 EST 1999 | Ross Berntson
| hi, | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier proces
Electronics Forum | Tue Jan 26 19:43:26 EST 1999 | Ross Berntson
| hi, | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier proces
Electronics Forum | Wed Nov 28 18:24:05 EST 2001 | mparker
Back in the days when pots, skillets, etc. were made of cast iron, vegetable oils were used to "season" the iron to prevent rusting and also from the food sticking to the pot during cooking. It would be reasonable to believe that you could use the sa
Electronics Forum | Mon Oct 21 18:15:13 EDT 2002 | cnoonan
Fuji: Wonderful machine, very robust, Hardware second to none. Lacking on software Universal: Love the GSM, great platform. Sanyo HSP�s are ok, like the new 4796, not sure about the 4797 yet, have not had it long enough to give good data. Sieme
Electronics Forum | Tue Sep 16 09:02:16 EDT 2003 | Graeme
Murtuza You have recieved loads of good info mainly all the preventive maintenance to be done. But can I ask was all of components placed twisted or just some when machine was run at full tact time 0.12s, I ask this as I run a 4791 and if its only so
Electronics Forum | Tue Apr 20 20:11:58 EDT 2004 | davef
First, how oxidized are these solder balls? Will the take solder using your routine flux / paste? Second, on restoring solderability, the three basic methods you can use to restore solderability on components are: * Highly active fluxes in a retinn
Electronics Forum | Mon May 10 20:46:25 EDT 2004 | davef
The three basic methods you can use to restore solderability on components are: * Highly active fluxes in a retinning operation. * Surface stripping chemistry and then a standard retinning operation. * Electrochemical conversion chemistry and then a
