Electronics Forum | Thu Nov 19 09:09:42 EST 2020 | kumarb
From the user forum... You need to modify the language flag inside the e5.ini file if you have the old software. C:E4 edienedit e5.ini Search for "postdfix", it will be on D like deutsch (german), change to GB (english). For the new soft
Electronics Forum | Sun Sep 26 21:41:36 EDT 2004 | mark_h
Hi All Thanks for your interesting replies :) At this stage I feel that we are leaning towards a second hand DEK 265 GSX vs a new EKRA E4 or X4, and with the saving made we will get it well refurbish and add a board loader, and hopefully a proflow
Electronics Forum | Mon Feb 23 12:22:32 EST 2004 | esoderberg
I have an MPM SPM and two Ekra E4 screen printers. I have always run them dry with vacuum. I am also using no-clean paste and have not had a problem. The volume I run per day on the machines is 4 - 6,000 bds
Electronics Forum | Thu May 26 07:07:26 EDT 2005 | ajaydoshi
We do have line configuration. EKRA E4, GL2, CP643, IP3, AOI 7550, BTUparagon150. What are the SPC tools used for SMD process control. I am looking for customized SPC software for trial to do process control on pre reflow, post reflow etc. any info ,
Electronics Forum | Thu Jun 09 07:02:02 EDT 2005 | ajaydoshi
1. We do have PCB with 0402 component, Micro BGA ( 0.5mm pitch , 0.25 mm pad size ). PCB thickness is 0.8mm. What stencil thickness we should use. PCB size 40 mm X 60 mm 2. We have EKRA E4 , What will be optimum setting for above. Pressure, Scquge s
Electronics Forum | Thu Jan 23 15:57:58 EST 2014 | bestglobalsmt
Hello! > > Go on the Service Button (bottom right) > password could be 2211 or 9060. In that menu you > should be able to change direction. > > Please > tell me if it works! > > Bye > > Christian christian - do you have any idea where the op
Electronics Forum | Mon Jan 27 14:34:02 EST 2014 | bestglobalsmt
Does anyone know if there is a standard administrator password. I have the operator level password and also the Service password but i cannot log into the mid level where you teach a program. is there a way to reset this? or is there a standard one
Electronics Forum | Fri Jun 12 08:37:21 EDT 2015 | cgreiner
Check to insure that cut outs in the PCB is not triggering the board sensor on the input of the unit. We had a few boards where the cutout in the board was seen as the end of the board and it would stop several inches from the board stop. We ended
Electronics Forum | Thu Mar 25 13:52:36 EDT 2021 | ephan
I bought this printer from a third-party source. The machine was running well until one day when we tried to turn it on and the screen just came up blank (I already checked if it was a monitor problem). Does anyone know why this happened and how to f
Electronics Forum | Mon Feb 24 12:14:07 EST 2003 | gilligan
We use an EKRA E4 printer, but the concept sounds the same as far as the fiducial alignment goes. I have found that SOT-23 components work the best for fiducials - and I always make it a point to use them on our older PCB's (where the screens do not