Electronics Forum | Tue Feb 08 23:29:54 EST 2005 | mrduckmann2000
Help! Does anyone know how to get a Camolot Gem II machine to put down dots for 0402 placement? I have been working with Electrovert Tech's that say their machine WILL place dots for 0402's. I have reduce the speed of the pumps to half the speed,
Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag
I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque
Electronics Forum | Fri May 15 14:50:40 EDT 2015 | emeto
My top 3 printers: 1.DEK 2.MPM 3.EKRA Top 3 ovens: 1. BTU 2. Vitronics 3. Heller or Electrovert
Electronics Forum | Mon Jan 15 13:12:18 EST 2007 | realchunks
So others can solder the same board and part but you can't. Dipping the legs in flux doesn't help. Then it's either your pre-heat or wave. Measure your pre-heat and compare to others or flux mfger. Do you have chip wave or something like an Omega
Electronics Forum | Fri May 22 17:48:48 EDT 2015 | aemery
It's your first line, go with established manufacturers. Whether new or used it ultimately comes down to does the tool do the job and how well is it supported (labor/parts) if it does break down. I am a former field eng. with Speedline and now run
Electronics Forum | Wed Jan 20 18:57:06 EST 2021 | echanelo
Hello, I'm in desperate need of a boot up disk for my Electrovert Omniflo 5 oven. Type: OMNI 5SE Date: 5/98 I would like to purchase or borrow. Or maybe someone can point me the right direction it would be greatly appreciated. Thanks
