Electronics Forum | Wed Mar 15 13:00:08 EST 2006 | jdumont
Hi Paul, I have been to the Novastar mfg plant in Penn. and to a demo of the TD Nu Era model also in Penn at Advanced Competitiveness Institute. After seeing both we have decided to go with the TD model. Im not sure where you are located but the regi
Electronics Forum | Sat May 21 07:51:08 EDT 2005 | jdengler
We would need more info to answer. How many boards get run between de-drossings? How many days between de-drossings? Are you removing dross only or some good solder with it? Jerry
Electronics Forum | Mon May 23 10:53:32 EDT 2005 | HOSS
Eric, We also have a UPK 650C. Our machine was configured for N2 and using the ConTour nozzle. If you're using this nozzle without N2 you're creating tons of dross unnecessarily not to mention probably getting tons of icicling. We found out the h
Electronics Forum | Mon Aug 08 14:21:54 EDT 2005 | Mitch DeCaire
I know this is not the appropriate forum for commercial content, but I wish to clarify how RFID technology is deployed within Cogiscan's solution. The most common configuration involves the attachment of an RFID tag to each Feeder (not to each Reel)
Electronics Forum | Fri Jul 02 17:15:52 EDT 2004 | Sam
You can't tell how a machine will perform on your particular board by looking at it place parts at a trade show. Usually they demo a best case scenario (parts in a simple grid pattern, few package types, etc.) You need to supply the board data for y
Electronics Forum | Wed Jun 23 10:05:17 EDT 2004 | exmaintenanceleader
Hi Grant, I'm ex Fuji service engineer I install also at Sagem Czecz Republik (Kladnow near Prague) in 2000 they use at new lines MPM- 2XCP643E and 1xUniversal GSM (French owen (I do not remember the exacly tipe) at second hand line they use 2x and
Electronics Forum | Mon Jan 12 08:02:06 EST 2015 | donb_68
I am interested in seeing de-panelization routers from ASYS and CTI in action. I am particularly interested in the Divisio 5100 and Divisio 2100 series routers from ASYS and the AR2020 and MR2 series routers from CTI. For the manual machines I would
Electronics Forum | Mon May 07 16:49:59 EDT 2001 | davef
Ashok, What in earthly heaven does this question have to do with "site support"? You can�t always get what you want, but sometimes you get what you need. Some leads are: * The proposed IPC cable/wire harness document is now IPC/WHMA-A-620 and go
Electronics Forum | Wed Mar 15 08:18:29 EDT 2017 | rob
It's well documented in higher power semiconductors where thermal interface materials are used, such as SIL pads, thermal grease etc. There are a couple of papers on the effects of voiding on MOSFET performance, but I haven't got around to reading
Electronics Forum | Wed May 27 07:53:41 EDT 2009 | padawanlinuxero
Thanks ! I will try your recommendations, about the flux and the preheaters, yes they seems to be ok I will bring down de conveyor speed because it looks like if it is to fast is set to 3.6ft thanks again!
.gif)
